[PATCH v3] ASoC: Intel: sof_rt5682: Add ALC1015Q-VB speaker amp support

[Pierre-Louis Bossart]

On 3/17/21 8:21 PM, Jack Yu wrote:
>>> This patch adds jsl_rt5682_rt1015p which supports the RT5682 headset
>>> codec and ALC1015Q-VB speaker amplifier combination on JasperLake
>>> platform.
>>>
>>> This driver also supports ALC1015Q-CG if running in auto-mode.
>>> Following table shows the audio interface support of the two
>>> amplifiers.
>>>
>>>             | ALC1015Q-CG | ALC1015Q-VB
>>> =====================================
>>> I2C       | Yes         | No
>>> Auto-mode | 48K, 64fs   | 16k, 32fs
>>>                           | 48k, 32fs
>>>                           | 48k, 64fs
>>>
>>> Signed-off-by: Brent Lu <brent.lu at intel.com>
>>
>> The code is looks fine, but Jack Yu added a separate patch that makes
>> RTL1019 equivalent to RTL1015, so should this patch also handle the
>> RTL1019 case?
>>
> For rt1019 non-i2c mode (auto mode), it uses the sdb pin to enable amp, the same as rt1015 non-i2c mode,
> therefore we propose rt1019(auto mode) to use rt1015p instead of adding a new driver for it.

ok, that's fine.

Acked-by: Pierre-Louis Bossart <pierre-louis.bossart at linux.intel.com>