[PATCH v3] ASoC: Intel: sof_rt5682: Add ALC1015Q-VB speaker amp support

[Jack Yu]

> > This patch adds jsl_rt5682_rt1015p which supports the RT5682 headset
> > codec and ALC1015Q-VB speaker amplifier combination on JasperLake
> > platform.
> >
> > This driver also supports ALC1015Q-CG if running in auto-mode.
> > Following table shows the audio interface support of the two
> > amplifiers.
> >
> >            | ALC1015Q-CG | ALC1015Q-VB
> > =====================================
> > I2C       | Yes         | No
> > Auto-mode | 48K, 64fs   | 16k, 32fs
> >                          | 48k, 32fs
> >                          | 48k, 64fs
> >
> > Signed-off-by: Brent Lu <brent.lu at intel.com>
> 
> The code is looks fine, but Jack Yu added a separate patch that makes
> RTL1019 equivalent to RTL1015, so should this patch also handle the
> RTL1019 case?
> 
For rt1019 non-i2c mode (auto mode), it uses the sdb pin to enable amp, the same as rt1015 non-i2c mode,
therefore we propose rt1019(auto mode) to use rt1015p instead of adding a new driver for it.