[alsa-devel] Gigabyte ALC889A Function ID: 0x01

[Jerry Geis]

Takashi Iwai wrote:
> At Wed, 15 Apr 2009 10:45:43 -0400,
> Jerry Geis wrote:
>   
>> Takashi Iwai wrote:
>>     
>>> At Wed, 15 Apr 2009 10:00:33 -0400,
>>> Jerry Geis wrote:
>>>   
>>>       
>>>> I am using the gigabyte MA78GM-US2H motherboard. it has the ALC889A audio.
>>>>
>>>> I am trying 1.0.19 and audio works out the analog back port but not over 
>>>> HDMI.
>>>>     
>>>>         
>>> Never mind about "Function ID" entry.  It's just a new line that was
>>> added recently.  function_id=1 means it's an audio codec.
>>>
>>> The way HDMI is supported are mainly either through the same audio
>>> codec (ALC889A) or through a dedicated HDMI codec.  In the former
>>> case, you'll likely see a word "HDMI" in the digital output pin of the
>>> codec proc file.  In the latter case, you must have a different codec
>>> chip connected to the HD-audio bus with a different codec address
>>> number.
>>>
>>>
>>> Takashi
>>>
>>>
>>>   
>>>       
>>>> Codec: Realtek ALC889A
>>>> Address: 0
>>>> Function Id: 0x1                                     
>>>> <--------------------------------- this is different
>>>> Vendor Id: 0x10ec0885
>>>> Subsystem Id: 0x1458a002
>>>> Revision Id: 0x100101
>>>> No Modem Function Group found
>>>> Default PCM:
>>>>     rates [0x560]: 44100 48000 96000 192000
>>>>     bits [0xe]: 16 20 24
>>>>     formats [0x1]: PCM
>>>> Default Amp-In caps: N/A
>>>> Default Amp-Out caps: N/A
>>>> GPIO: io=2, o=0, i=0, unsolicited=1, wake=0
>>>>   IO[0]: enable=0, dir=0, wake=0, sticky=0, data=0, unsol=0
>>>>   IO[1]: enable=0, dir=0, wake=0, sticky=0, data=0, unsol=0
>>>> Node 0x02 [Audio Output] wcaps 0x11: Stereo
>>>>   Converter: stream=0, channel=0
>>>>   PCM:
>>>>     rates [0x560]: 44100 48000 96000 192000
>>>>     bits [0xe]: 16 20 24
>>>>     formats [0x1]: PCM
>>>> Node 0x03 [Audio Output] wcaps 0x11: Stereo
>>>>
>>>> I have been looking but havent found a solution yet. I tried grabbing 
>>>> the snapshot tar ball for today but I get errors on the compile.
>>>>
>>>> I had a similiar motherboard but it does not report Function ID: 01 : - 
>>>> HDMI audio on this board works correctly.
>>>> Codec: Realtek ALC889A
>>>> Address: 0
>>>> Vendor Id: 0x10ec0885
>>>> Subsystem Id: 0x1458a002
>>>> Revision Id: 0x100101
>>>> No Modem Function Group found
>>>> Default PCM:
>>>>     rates [0x560]: 44100 48000 96000 192000
>>>>
>>>> Any thoughts????
>>>>
>>>> Jerry
>>>> _______________________________________________
>>>> Alsa-devel mailing list
>>>> Alsa-devel at alsa-project.org
>>>> http://mailman.alsa-project.org/mailman/listinfo/alsa-devel
>>>>
>>>>     
>>>>         
>>>   
>>>       
>> I upload alsa-info.sh
>>
>> for the NOT WORKIng one 
>> http://www.alsa-project.org/db/?f=7e8bc9485e8bb98bf15dae5a0d5dc038003c3203
>>
>> for the working on 
>> http://www.alsa-project.org/db/?f=a18bcb6e87fe33a7365a749d0877a4546e901bf2
>>     
>
> How are you testing HDMI output?
>
>
> Takashi
>
>   
I have a sharp aquos HDMI that works with the other motherboard.

I am just switching between the two.

I have the asound.conf set to the correct hw:X,y on both machines for HDMI.

Jerry