[PATCH 02/19] soundwire: amd: Add support for AMD Master driver

[Amadeusz Sławiński]

On 1/11/2023 10:02 AM, Vijendar Mukunda wrote:
> AMD ACP IP block has two soundwire controller devices.
> Add support for
> - Master driver probe & remove sequence
> - Helper functions to enable/disable interrupts, Initialize sdw controller,
>    enable sdw pads
> - Master driver sdw_master_ops & port_ops callbacks
> 
> Signed-off-by: Vijendar Mukunda <Vijendar.Mukunda at amd.com>
> ---

...

> +
> +static int amd_sdwc_compute_params(struct sdw_bus *bus)
> +{
> +	struct sdw_transport_data t_data = {0};
> +	struct sdw_master_runtime *m_rt;
> +	struct sdw_port_runtime *p_rt;
> +	struct sdw_bus_params *b_params = &bus->params;
> +	int port_bo, hstart, hstop, sample_int;
> +	unsigned int rate, bps;
> +
> +	port_bo  = 0;

Double space before '='.

> +	hstart = 1;
> +	hstop = bus->params.col - 1;
> +	t_data.hstop = hstop;
> +	t_data.hstart = hstart;
> +
> +	list_for_each_entry(m_rt, &bus->m_rt_list, bus_node) {
> +		rate = m_rt->stream->params.rate;
> +		bps = m_rt->stream->params.bps;
> +		sample_int = (bus->params.curr_dr_freq / rate);
> +		list_for_each_entry(p_rt, &m_rt->port_list, port_node) {
> +			port_bo = (p_rt->num * 64) + 1;
> +			dev_dbg(bus->dev, "p_rt->num=%d hstart=%d hstop=%d port_bo=%d\n",
> +				p_rt->num, hstart, hstop, port_bo);
> +			sdw_fill_xport_params(&p_rt->transport_params, p_rt->num,
> +					      false, SDW_BLK_GRP_CNT_1, sample_int,
> +					      port_bo, port_bo >> 8, hstart, hstop,
> +					      SDW_BLK_PKG_PER_PORT, 0x0);
> +
> +			sdw_fill_port_params(&p_rt->port_params,
> +					     p_rt->num, bps,
> +					     SDW_PORT_FLOW_MODE_ISOCH,
> +					     b_params->m_data_mode);
> +			t_data.hstart = hstart;
> +			t_data.hstop = hstop;
> +			t_data.block_offset = port_bo;
> +			t_data.sub_block_offset = 0;
> +		}
> +		amd_sdwc_compute_slave_ports(m_rt, &t_data);
> +	}
> +	return 0;
> +}
> +

...

> +
> +static int amd_sdwc_port_enable(struct sdw_bus *bus,
> +				struct sdw_enable_ch *enable_ch,
> +				unsigned int bank)
> +{
> +	struct amd_sdwc_ctrl *ctrl = to_amd_sdw(bus);
> +	u32 dpn_ch_enable;
> +	u32 ch_enable_reg, channel_type;
> +
> +	switch (ctrl->instance) {
> +	case ACP_SDW0:
> +		channel_type = enable_ch->port_num;
> +		break;
> +	case ACP_SDW1:
> +		channel_type = enable_ch->port_num + ACP_SDW0_MAX_DAI;
> +		break;
> +	default:
> +		return -EINVAL;
> +	}
> +
> +	switch (channel_type) {
> +	case ACP_SDW0_AUDIO_TX:
> +		ch_enable_reg = ACP_SW_AUDIO_TX_CHANNEL_ENABLE_DP0;
> +		break;
> +	case ACP_SDW0_HS_TX:
> +		ch_enable_reg = ACP_SW_HEADSET_TX_CHANNEL_ENABLE_DP0;
> +		break;
> +	case ACP_SDW0_BT_TX:
> +		ch_enable_reg = ACP_SW_BT_TX_CHANNEL_ENABLE_DP0;
> +		break;
> +	case ACP_SDW1_BT_TX:
> +		ch_enable_reg = ACP_P1_SW_BT_TX_CHANNEL_ENABLE_DP0;
> +		break;
> +	case ACP_SDW0_AUDIO_RX:
> +		ch_enable_reg = ACP_SW_AUDIO_RX_CHANNEL_ENABLE_DP0;
> +		break;
> +	case ACP_SDW0_HS_RX:
> +		ch_enable_reg = ACP_SW_HEADSET_RX_CHANNEL_ENABLE_DP0;
> +		break;
> +	case ACP_SDW0_BT_RX:
> +		ch_enable_reg = ACP_SW_BT_RX_CHANNEL_ENABLE_DP0;
> +		break;
> +	case ACP_SDW1_BT_RX:
> +		ch_enable_reg = ACP_P1_SW_BT_RX_CHANNEL_ENABLE_DP0;
> +		break;
> +	default:
> +		dev_err(bus->dev, "%s:Invalid channel:%d\n", __func__, channel_type);
> +		return -EINVAL;
> +	}
> +
> +	dpn_ch_enable =  acp_reg_readl(ctrl->mmio + ch_enable_reg);

Double space after '='.

> +	u32p_replace_bits(&dpn_ch_enable, enable_ch->ch_mask, AMD_DPN_CH_EN_CHMASK);
> +	if (enable_ch->enable)
> +		acp_reg_writel(dpn_ch_enable, ctrl->mmio + ch_enable_reg);
> +	else
> +		acp_reg_writel(0, ctrl->mmio + ch_enable_reg);
> +	return 0;
> +}
> +

...

> +
> +static void amd_sdwc_probe_work(struct work_struct *work)
> +{
> +	struct amd_sdwc_ctrl *ctrl  = container_of(work, struct amd_sdwc_ctrl, probe_work);

Double space before '='.

> +	struct sdw_master_prop *prop;
> +	int ret;
> +
> +	prop = &ctrl->bus.prop;
> +	if (!prop->hw_disabled) {
> +		ret = amd_enable_sdw_pads(ctrl);
> +		if (ret)
> +			return;
> +		ret = amd_init_sdw_controller(ctrl);
> +		if (ret)
> +			return;
> +		amd_enable_sdw_interrupts(ctrl);
> +		ret = amd_enable_sdw_controller(ctrl);
> +		if (ret)
> +			return;
> +		ret = amd_sdwc_set_frameshape(ctrl, 50, 10);
> +		if (!ret)
> +			ctrl->startup_done = true;
> +	}
> +}
> +
> +static int amd_sdwc_probe(struct platform_device *pdev)
> +{
> +	const struct acp_sdw_pdata *pdata = pdev->dev.platform_data;
> +	struct resource *res;
> +	struct device *dev = &pdev->dev;

Same as in previous patch, you assign dev here, but keep using 
&pdev->dev below?

> +	struct sdw_master_prop *prop;
> +	struct sdw_bus_params *params;
> +	struct amd_sdwc_ctrl *ctrl;
> +	int ret;
> +
> +	if (!pdev->dev.platform_data) {
> +		dev_err(&pdev->dev, "platform_data not retrieved\n");
> +		return -ENODEV;
> +	}
> +	ctrl = devm_kzalloc(&pdev->dev, sizeof(struct amd_sdwc_ctrl), GFP_KERNEL);
> +	if (!ctrl)
> +		return -ENOMEM;
> +	res = platform_get_resource(pdev, IORESOURCE_MEM, 0);
> +	if (!res) {
> +		dev_err(&pdev->dev, "IORESOURCE_MEM FAILED\n");
> +		return -ENOMEM;
> +	}
> +	ctrl->mmio = devm_ioremap(&pdev->dev, res->start, resource_size(res));
> +	if (IS_ERR(ctrl->mmio)) {
> +		dev_err(&pdev->dev, "mmio not found\n");
> +		return PTR_ERR(ctrl->mmio);
> +	}
> +	ctrl->instance = pdata->instance;
> +	ctrl->sdw_lock  = pdata->sdw_lock;

Double space before '='.

> +	ctrl->rows_index = sdw_find_row_index(50);
> +	ctrl->cols_index = sdw_find_col_index(10);
> +
> +	ctrl->dev = dev;
> +	dev_set_drvdata(&pdev->dev, ctrl);
> +
> +	ctrl->bus.ops = &amd_sdwc_ops;
> +	ctrl->bus.port_ops = &amd_sdwc_port_ops;
> +	ctrl->bus.compute_params = &amd_sdwc_compute_params;
> +	ctrl->bus.clk_stop_timeout = 1;
> +	switch (ctrl->instance) {
> +	case ACP_SDW0:
> +		ctrl->num_dout_ports =  AMD_SDW0_MAX_TX_PORTS;

Double space after '='.

> +		ctrl->num_din_ports = AMD_SDW0_MAX_RX_PORTS;
> +		break;
> +	case ACP_SDW1:
> +		ctrl->num_dout_ports = AMD_SDW1_MAX_TX_PORTS;
> +		ctrl->num_din_ports = AMD_SDW1_MAX_RX_PORTS;
> +		break;
> +	default:
> +		return -EINVAL;
> +	}
> +	params = &ctrl->bus.params;
> +	params->max_dr_freq = AMD_SDW_DEFAULT_CLK_FREQ * 2;
> +	params->curr_dr_freq = AMD_SDW_DEFAULT_CLK_FREQ * 2;
> +	params->col = 10;
> +	params->row = 50;
> +
> +	prop = &ctrl->bus.prop;
> +	prop->clk_freq = &amd_sdwc_freq_tbl[0];
> +	prop->mclk_freq = AMD_SDW_BUS_BASE_FREQ;
> +	ctrl->bus.link_id = ctrl->instance;
> +	ret = sdw_bus_master_add(&ctrl->bus, dev, dev->fwnode);
> +	if (ret) {
> +		dev_err(dev, "Failed to register Soundwire controller (%d)\n",
> +			ret);
> +		return ret;
> +	}
> +	INIT_WORK(&ctrl->probe_work, amd_sdwc_probe_work);
> +	schedule_work(&ctrl->probe_work);
> +	return 0;
> +}
> +
> +static int amd_sdwc_remove(struct platform_device *pdev)
> +{
> +	struct amd_sdwc_ctrl *ctrl = dev_get_drvdata(&pdev->dev);
> +	int ret;
> +

You may need to cancel work if someone tries to unload driver before 
probe work completes. Something like

cancel_work_sync(&ctrl->probe_work);

should probably work here.

> +	amd_disable_sdw_interrupts(ctrl);
> +	sdw_bus_master_delete(&ctrl->bus);
> +	ret = amd_disable_sdw_controller(ctrl);
> +	return ret;
> +}
> +