[PATCH 1/2] slimbus: stream: handle unsupported bitrates for presence rate

[Krzysztof Kozlowski]

Handle errors of getting presence rate for unsupported stream bitrate,
instead of sending -EINVAL in change content message.

Signed-off-by: Krzysztof Kozlowski <krzysztof.kozlowski at linaro.org>
---
 drivers/slimbus/stream.c | 11 +++++++++--
 1 file changed, 9 insertions(+), 2 deletions(-)

diff --git a/drivers/slimbus/stream.c b/drivers/slimbus/stream.c
index f8eade1e0132..28fbecb3907d 100644
--- a/drivers/slimbus/stream.c
+++ b/drivers/slimbus/stream.c
@@ -204,7 +204,7 @@ int slim_stream_prepare(struct slim_stream_runtime *rt,
 {
 	struct slim_controller *ctrl = rt->dev->ctrl;
 	struct slim_port *port;
-	int num_ports, i, port_id;
+	int num_ports, i, port_id, prrate;
 
 	pr_err("%s:%d AAAA\n", __func__, __LINE__);
 	if (rt->ports) {
@@ -222,6 +222,13 @@ int slim_stream_prepare(struct slim_stream_runtime *rt,
 	rt->bps = cfg->bps;
 	rt->direction = cfg->direction;
 
+	prrate = slim_get_prate_code(cfg->rate);
+	if (prrate < 0) {
+		dev_err(&rt->dev->dev, "Cannot get presence rate for rate %d Hz\n",
+			cfg->rate);
+		return -EINVAL;
+	}
+
 	if (cfg->rate % ctrl->a_framer->superfreq) {
 		/*
 		 * data rate not exactly multiple of super frame,
@@ -242,7 +249,7 @@ int slim_stream_prepare(struct slim_stream_runtime *rt,
 		port = &rt->ports[i];
 		port->state = SLIM_PORT_DISCONNECTED;
 		port->id = port_id;
-		port->ch.prrate = slim_get_prate_code(cfg->rate);
+		port->ch.prrate = prrate;
 		port->ch.id = cfg->chs[i];
 		port->ch.data_fmt = SLIM_CH_DATA_FMT_NOT_DEFINED;
 		port->ch.aux_fmt = SLIM_CH_AUX_FMT_NOT_APPLICABLE;
-- 
2.34.1