[PATCH v2 54/65] clk: da8xx: clk48: Switch to determine_rate

[David Lechner]

On 11/4/22 8:18 AM, Maxime Ripard wrote:
> The TI DA8xx USB0 clk48 clocks implements a mux with a set_parent
> hook, but doesn't provide a determine_rate implementation.
> 
> This is a bit odd, since set_parent() is there to, as its name implies,
> change the parent of a clock. However, the most likely candidate to
> trigger that parent change is a call to clk_set_rate(), with
> determine_rate() figuring out which parent is the best suited for a
> given rate.
> 
> The other trigger would be a call to clk_set_parent(), but it's far less
> used, and it doesn't look like there's any obvious user for that clock.
> 
> So, the set_parent hook is effectively unused, possibly because of an
> oversight. However, it could also be an explicit decision by the
> original author to avoid any reparenting but through an explicit call to
> clk_set_parent().
> 
> The driver does implement round_rate() though, which means that we can
> change the rate of the clock, but we will never get to change the
> parent.
> 
> However, It's hard to tell whether it's been done on purpose or not.
> 
> Since we'll start mandating a determine_rate() implementation, let's
> convert the round_rate() implementation to a determine_rate(), which
> will also make the current behavior explicit. And if it was an
> oversight, the clock behaviour can be adjusted later on.

I think this one should be the same as the clk:davinci changes and
not allow re-parenting. Since this is a USB 48MHz PHY clock, a rate
change will never be requested.

> 
> Signed-off-by: Maxime Ripard <maxime at cerno.tech>
> ---
>   drivers/clk/davinci/da8xx-cfgchip.c | 10 ++++++----
>   1 file changed, 6 insertions(+), 4 deletions(-)
> 
> diff --git a/drivers/clk/davinci/da8xx-cfgchip.c b/drivers/clk/davinci/da8xx-cfgchip.c
> index 4c1cc59bba53..f60c97091818 100644
> --- a/drivers/clk/davinci/da8xx-cfgchip.c
> +++ b/drivers/clk/davinci/da8xx-cfgchip.c
> @@ -462,10 +462,12 @@ static unsigned long da8xx_usb0_clk48_recalc_rate(struct clk_hw *hw,
>   	return 48000000;
>   }
>   
> -static long da8xx_usb0_clk48_round_rate(struct clk_hw *hw, unsigned long rate,
> -					unsigned long *parent_rate)
> +static int da8xx_usb0_clk48_determine_rate(struct clk_hw *hw,
> +					   struct clk_rate_request *req)
>   {
> -	return 48000000;
> +	req->rate = 48000000;
> +
> +	return 0;
>   }
>   
>   static int da8xx_usb0_clk48_set_parent(struct clk_hw *hw, u8 index)
> @@ -494,7 +496,7 @@ static const struct clk_ops da8xx_usb0_clk48_ops = {
>   	.disable	= da8xx_usb0_clk48_disable,
>   	.is_enabled	= da8xx_usb0_clk48_is_enabled,
>   	.recalc_rate	= da8xx_usb0_clk48_recalc_rate,
> -	.round_rate	= da8xx_usb0_clk48_round_rate,
> +	.determine_rate	= da8xx_usb0_clk48_determine_rate,
>   	.set_parent	= da8xx_usb0_clk48_set_parent,
>   	.get_parent	= da8xx_usb0_clk48_get_parent,
>   };
>