[PATCH] soundwire: qcom: Update error prints to debug prints

[Pierre-Louis Bossart]

On 7/13/22 07:22, Srinivasa Rao Mandadapu wrote:
> Upadte error prints to debug prints to avoid redundant logging in kernel

update

> boot time, as these prints are informative prints in irq handler.
> 
> Signed-off-by: Srinivasa Rao Mandadapu <quic_srivasam at quicinc.com>
> ---
>  drivers/soundwire/qcom.c | 5 ++---
>  1 file changed, 2 insertions(+), 3 deletions(-)
> 
> diff --git a/drivers/soundwire/qcom.c b/drivers/soundwire/qcom.c
> index 9df970e..a4293d0 100644
> --- a/drivers/soundwire/qcom.c
> +++ b/drivers/soundwire/qcom.c
> @@ -573,11 +573,10 @@ static irqreturn_t qcom_swrm_irq_handler(int irq, void *dev_id)
>  				break;
>  			case SWRM_INTERRUPT_STATUS_NEW_SLAVE_ATTACHED:
>  			case SWRM_INTERRUPT_STATUS_CHANGE_ENUM_SLAVE_STATUS:
> -				dev_err_ratelimited(swrm->dev, "%s: SWR new slave attached\n",
> -					__func__);
> +				dev_dbg(swrm->dev, "%s: SWR new slave attached\n", __func__);

any reason why the rate limitation was dropped?

>  				swrm->reg_read(swrm, SWRM_MCP_SLV_STATUS, &slave_status);
>  				if (swrm->slave_status == slave_status) {
> -					dev_err(swrm->dev, "Slave status not changed %x\n",
> +					dev_dbg(swrm->dev, "Slave status not changed %x\n",
>  						slave_status);
>  				} else {
>  					qcom_swrm_get_device_status(swrm);