[PATCH 24/26] ALSA: hda: cs35l41: Add defaulted values into dsp bypass config sequence
Vitaly Rodionov
vitalyr at opensource.cirrus.com
Wed Apr 27 17:07:18 CEST 2022
From: Stefan Binding <sbinding at opensource.cirrus.com>
The config sequences for running with and without firmware and DSP
are different. The original behavior assumed that we would only
run without DSP only in the case where firmware load failed.
This meant the non-firmware sequence was written with the assumtion
that various registers would be set to their default value.
However, to support the ability to unload the firmware, the
non-firmware register sequence must be updated to update all
required registers, including values that would be defaulted,
in case the firmware sequence, which could have already run,
has changed their value.
Signed-off-by: Stefan Binding <sbinding at opensource.cirrus.com>
Signed-off-by: Vitaly Rodionov <vitalyr at opensource.cirrus.com>
---
sound/pci/hda/cs35l41_hda.c | 13 +++++++++++++
1 file changed, 13 insertions(+)
diff --git a/sound/pci/hda/cs35l41_hda.c b/sound/pci/hda/cs35l41_hda.c
index 7e87b355b369..0eca85f3c80e 100644
--- a/sound/pci/hda/cs35l41_hda.c
+++ b/sound/pci/hda/cs35l41_hda.c
@@ -37,11 +37,24 @@ static efi_guid_t efi_guid = CIRRUS_EFI_GUID;
static const struct reg_sequence cs35l41_hda_config[] = {
{ CS35L41_PLL_CLK_CTRL, 0x00000430 }, // 3072000Hz, BCLK Input, PLL_REFCLK_EN = 1
+ { CS35L41_DSP_CLK_CTRL, 0x00000003 }, // DSP CLK EN
{ CS35L41_GLOBAL_CLK_CTRL, 0x00000003 }, // GLOBAL_FS = 48 kHz
{ CS35L41_SP_ENABLES, 0x00010000 }, // ASP_RX1_EN = 1
{ CS35L41_SP_RATE_CTRL, 0x00000021 }, // ASP_BCLK_FREQ = 3.072 MHz
{ CS35L41_SP_FORMAT, 0x20200200 }, // 32 bits RX/TX slots, I2S, clk consumer
+ { CS35L41_SP_HIZ_CTRL, 0x00000002 }, // Hi-Z unused
+ { CS35L41_SP_TX_WL, 0x00000018 }, // 24 cycles/slot
+ { CS35L41_SP_RX_WL, 0x00000018 }, // 24 cycles/slot
{ CS35L41_DAC_PCM1_SRC, 0x00000008 }, // DACPCM1_SRC = ASPRX1
+ { CS35L41_ASP_TX1_SRC, 0x00000018 }, // ASPTX1 SRC = VMON
+ { CS35L41_ASP_TX2_SRC, 0x00000019 }, // ASPTX2 SRC = IMON
+ { CS35L41_ASP_TX3_SRC, 0x00000032 }, // ASPTX3 SRC = ERRVOL
+ { CS35L41_ASP_TX4_SRC, 0x00000033 }, // ASPTX4 SRC = CLASSH_TGT
+ { CS35L41_DSP1_RX1_SRC, 0x00000008 }, // DSP1RX1 SRC = ASPRX1
+ { CS35L41_DSP1_RX2_SRC, 0x00000009 }, // DSP1RX2 SRC = ASPRX2
+ { CS35L41_DSP1_RX3_SRC, 0x00000018 }, // DSP1RX3 SRC = VMON
+ { CS35L41_DSP1_RX4_SRC, 0x00000019 }, // DSP1RX4 SRC = IMON
+ { CS35L41_DSP1_RX5_SRC, 0x00000020 }, // DSP1RX5 SRC = ERRVOL
{ CS35L41_AMP_DIG_VOL_CTRL, 0x00000000 }, // AMP_VOL_PCM 0.0 dB
{ CS35L41_AMP_GAIN_CTRL, 0x00000084 }, // AMP_GAIN_PCM 4.5 dB
};
--
2.32.0
More information about the Alsa-devel
mailing list