[PATCH 1/2] ASoC: cs42l42: Reset and power-down on remove() and failed probe()

Richard Fitzgerald rf at opensource.cirrus.com
Tue Oct 26 14:57:21 CEST 2021


Driver remove() should assert RESET and disable the supplies.

probe() fail was disabling supplies but it didn't assert reset or
put the codec into a power-down state.

Signed-off-by: Richard Fitzgerald <rf at opensource.cirrus.com>
---
 sound/soc/codecs/cs42l42.c | 24 ++++++++++++++++++++----
 1 file changed, 20 insertions(+), 4 deletions(-)

diff --git a/sound/soc/codecs/cs42l42.c b/sound/soc/codecs/cs42l42.c
index a8fff274ec63..dc12842ee6e1 100644
--- a/sound/soc/codecs/cs42l42.c
+++ b/sound/soc/codecs/cs42l42.c
@@ -2067,7 +2067,7 @@ static int cs42l42_i2c_probe(struct i2c_client *i2c_client,
 		"reset", GPIOD_OUT_LOW);
 	if (IS_ERR(cs42l42->reset_gpio)) {
 		ret = PTR_ERR(cs42l42->reset_gpio);
-		goto err_disable;
+		goto err_disable_noreset;
 	}
 
 	if (cs42l42->reset_gpio) {
@@ -2111,7 +2111,7 @@ static int cs42l42_i2c_probe(struct i2c_client *i2c_client,
 	ret = regmap_read(cs42l42->regmap, CS42L42_REVID, &reg);
 	if (ret < 0) {
 		dev_err(&i2c_client->dev, "Get Revision ID failed\n");
-		goto err_disable;
+		goto err_shutdown;
 	}
 
 	dev_info(&i2c_client->dev,
@@ -2136,7 +2136,7 @@ static int cs42l42_i2c_probe(struct i2c_client *i2c_client,
 
 	ret = cs42l42_handle_device_data(&i2c_client->dev, cs42l42);
 	if (ret != 0)
-		goto err_disable;
+		goto err_shutdown;
 
 	/* Setup headset detection */
 	cs42l42_setup_hs_type_detect(cs42l42);
@@ -2148,10 +2148,18 @@ static int cs42l42_i2c_probe(struct i2c_client *i2c_client,
 	ret = devm_snd_soc_register_component(&i2c_client->dev,
 			&soc_component_dev_cs42l42, &cs42l42_dai, 1);
 	if (ret < 0)
-		goto err_disable;
+		goto err_shutdown;
+
 	return 0;
 
+err_shutdown:
+	regmap_write(cs42l42->regmap, CS42L42_CODEC_INT_MASK, 0xff);
+	regmap_write(cs42l42->regmap, CS42L42_TSRS_PLUG_INT_MASK, 0xff);
+	regmap_write(cs42l42->regmap, CS42L42_PWR_CTL1, 0xff);
+
 err_disable:
+	gpiod_set_value_cansleep(cs42l42->reset_gpio, 0);
+err_disable_noreset:
 	regulator_bulk_disable(ARRAY_SIZE(cs42l42->supplies),
 				cs42l42->supplies);
 	return ret;
@@ -2164,6 +2172,14 @@ static int cs42l42_i2c_remove(struct i2c_client *i2c_client)
 	if (i2c_client->irq)
 		devm_free_irq(&i2c_client->dev, i2c_client->irq, cs42l42);
 
+	/*
+	 * The driver might not have control of reset and power supplies,
+	 * so ensure that the chip internals are powered down.
+	 */
+	regmap_write(cs42l42->regmap, CS42L42_CODEC_INT_MASK, 0xff);
+	regmap_write(cs42l42->regmap, CS42L42_TSRS_PLUG_INT_MASK, 0xff);
+	regmap_write(cs42l42->regmap, CS42L42_PWR_CTL1, 0xff);
+
 	gpiod_set_value_cansleep(cs42l42->reset_gpio, 0);
 	regulator_bulk_disable(ARRAY_SIZE(cs42l42->supplies), cs42l42->supplies);
 
-- 
2.11.0



More information about the Alsa-devel mailing list