Adding movable PCIe BARs support in snd_hda_intel

[Takashi Iwai]

On Wed, 24 Mar 2021 22:43:24 +0100,
Andrey Grodzovsky wrote:
> 
> Few comments -
> 
> 1) Why we don't use snd_power_wait_and_ref in patch 3 in the common
> handler ?
> Don't we want the PCI rescan sequence to 'wait for' any in flight
> taks that might be accessing registers and not only read/write/tlv
> accesses ?

Right, we don't need to block all ioctls, but only the ones that may
access the hardware.  So basically the patches 3-5 can be dropped if
we take the patch 6.  The current patch was written on top of the
previous series, that's why it has both.

> 2) Possible deadlock -
> In azx_rescan_prepare - you put the card into SNDRV_CTL_POWER_D3hot
> first and then 'wait for' all in flight tasks with the refcount.
> The in flight tasks on the other hand, using snd_power_wait_and_ref,
> may have already bumped up the refcount and now 'wait for' the card
> to go into SNDRV_CTL_POWER_D0 which can't happen since PCI rescan
> waits for the refocunt to drop to 0 before proceeding.
> 
> Instead of snd_power_wait_and_ref can't we just call snd_power_ref
> in common IOCTL before checking for power_state != SNDRV_CTL_POWER_D0 ?
> Or is it because you don't want to fail IOCTLs ?

No, this is the intended behavior and should work as-is because
snd_power_wait_and_ref() drops the refcount in the loop before
sleeping.  The inc before the state check is a must for covering the
possible race, and ditto for changing the power_state to D3hot before
syncing.


Takashi