[PATCH v2 3/5] soundwire: qcom: add static port map support

[Pierre-Louis Bossart]

>   	list_for_each_entry(m_rt, &bus->m_rt_list, bus_node) {
> @@ -473,8 +475,13 @@ static int qcom_swrm_compute_params(struct sdw_bus *bus)
>   		}
>   
>   		list_for_each_entry(s_rt, &m_rt->slave_rt_list, m_rt_node) {
> +			slave = s_rt->slave;
>   			list_for_each_entry(p_rt, &s_rt->port_list, port_node) {
> -				pcfg = &ctrl->pconfig[i];
> +				m_port = slave->m_port_map[_rtp->num - 1];
> +				if (m_port)
> +					pcfg = &ctrl->pconfig[m_port - 1];
> +				else
> +					pcfg = &ctrl->pconfig[i];

Maybe add a short comment on port allocation, I had to think a bit to 
figure out why the -1 was required on both peripheral and manager but it 
is not below [1]

>   				p_rt->transport_params.port_num = p_rt->num;
>   				p_rt->transport_params.sample_interval =
>   					pcfg->si + 1;
> @@ -535,8 +542,10 @@ static int qcom_swrm_stream_alloc_ports(struct qcom_swrm_ctrl *ctrl,
>   	struct sdw_master_runtime *m_rt;
>   	struct sdw_slave_runtime *s_rt;
>   	struct sdw_port_runtime *p_rt;
> +	struct sdw_slave *slave;
>   	unsigned long *port_mask;
>   	int i, maxport, pn, nports = 0, ret = 0;
> +	unsigned int m_port;
>   
>   	mutex_lock(&ctrl->port_lock);
>   	list_for_each_entry(m_rt, &stream->master_list, stream_node) {
> @@ -549,9 +558,15 @@ static int qcom_swrm_stream_alloc_ports(struct qcom_swrm_ctrl *ctrl,
>   		}
>   
>   		list_for_each_entry(s_rt, &m_rt->slave_rt_list, m_rt_node) {
> +			slave = s_rt->slave;
>   			list_for_each_entry(p_rt, &s_rt->port_list, port_node) {
> +				m_port = slave->m_port_map[p_rt->num - 1];
>   				/* Port numbers start from 1 - 14*/
> -				pn = find_first_zero_bit(port_mask, maxport);
> +				if (m_port)
> +					pn = m_port;
> +				else
> +					pn = find_first_zero_bit(port_mask, maxport);

[1]

> +
>   				if (pn > (maxport)) {
>   					dev_err(ctrl->dev, "All ports busy\n");
>   					ret = -EBUSY;
>