[PATCH 07/12] ASoC: amd: add ACP5x pcm dma driver ops
Mukunda,Vijendar
vijendar.mukunda at amd.com
Thu Jul 8 13:56:42 CEST 2021
On 7/7/21 9:57 PM, Pierre-Louis Bossart wrote:
>
>
> On 7/7/21 12:56 AM, Vijendar Mukunda wrote:
>> This patch adds ACP5x PCM driver DMA operations.
>>
>> Signed-off-by: Vijendar Mukunda <Vijendar.Mukunda at amd.com>
>> ---
>> sound/soc/amd/vangogh/acp5x-pcm-dma.c | 306 +++++++++++++++++++++++++-
>> sound/soc/amd/vangogh/acp5x.h | 106 +++++++++
>> 2 files changed, 410 insertions(+), 2 deletions(-)
>>
>> diff --git a/sound/soc/amd/vangogh/acp5x-pcm-dma.c b/sound/soc/amd/vangogh/acp5x-pcm-dma.c
>> index d79712587d30..a4235cf33548 100644
>> --- a/sound/soc/amd/vangogh/acp5x-pcm-dma.c
>> +++ b/sound/soc/amd/vangogh/acp5x-pcm-dma.c
>> @@ -17,8 +17,42 @@
>>
>> #define DRV_NAME "acp5x_i2s_dma"
>>
>> -static const struct snd_soc_component_driver acp5x_i2s_component = {
>> - .name = DRV_NAME,
>> +static const struct snd_pcm_hardware acp5x_pcm_hardware_playback = {
>> + .info = SNDRV_PCM_INFO_INTERLEAVED |
>> + SNDRV_PCM_INFO_BLOCK_TRANSFER |
>> + SNDRV_PCM_INFO_MMAP | SNDRV_PCM_INFO_MMAP_VALID |
>> + SNDRV_PCM_INFO_PAUSE | SNDRV_PCM_INFO_RESUME,
>> + .formats = SNDRV_PCM_FMTBIT_S16_LE | SNDRV_PCM_FMTBIT_S8 |
>> + SNDRV_PCM_FMTBIT_U8 | SNDRV_PCM_FMTBIT_S32_LE,
>
> is S24_4LE supported? seems more useful than 8-bit audio these days, no?
AMD I2S controller doesn't support S24_LE format.
>
>> +static void config_acp5x_dma(struct i2s_stream_instance *rtd, int direction)
>> +{
>> + u16 page_idx;
>> + u32 low, high, val, acp_fifo_addr, reg_fifo_addr;
>> + u32 reg_dma_size, reg_fifo_size;
>> + dma_addr_t addr;
>> +
>> + addr = rtd->dma_addr;
>> + if (direction == SNDRV_PCM_STREAM_PLAYBACK) {
>> + switch (rtd->i2s_instance) {
>> + case I2S_HS_INSTANCE:
>> + val = ACP_SRAM_HS_PB_PTE_OFFSET;
>> + break;
>> + case I2S_SP_INSTANCE:
>> + default:
>> + val = ACP_SRAM_SP_PB_PTE_OFFSET;
>> + }
>> + } else {
>> + switch (rtd->i2s_instance) {
>> + case I2S_HS_INSTANCE:
>> + val = ACP_SRAM_HS_CP_PTE_OFFSET;
>> + break;
>> + case I2S_SP_INSTANCE:
>> + default:
>> + val = ACP_SRAM_SP_CP_PTE_OFFSET;
>> + }
>> + }
>> + /* Group Enable */
>> + acp_writel(ACP_SRAM_PTE_OFFSET | BIT(31), rtd->acp5x_base +
>> + ACPAXI2AXI_ATU_BASE_ADDR_GRP_1);
>> + acp_writel(PAGE_SIZE_4K_ENABLE, rtd->acp5x_base +
>> + ACPAXI2AXI_ATU_PAGE_SIZE_GRP_1);
>> +
>> + for (page_idx = 0; page_idx < rtd->num_pages; page_idx++) {
>> + /* Load the low address of page int ACP SRAM through SRBM */
>> + low = lower_32_bits(addr);
>> + high = upper_32_bits(addr);
>> +
>> + acp_writel(low, rtd->acp5x_base + ACP_SCRATCH_REG_0 + val);
>> + high |= BIT(31);
>> + acp_writel(high, rtd->acp5x_base + ACP_SCRATCH_REG_0 + val
>> + + 4);
>
> use single line? I find the indentation style quite an eyesore...
will fix the indentation style.
>
>
>> + /* Move to next physically contiguous page */
>> + val += 8;
>> + addr += PAGE_SIZE;
>> + }
>> +
>> + if (direction == SNDRV_PCM_STREAM_PLAYBACK) {
>> + switch (rtd->i2s_instance) {
>> + case I2S_HS_INSTANCE:
>> + reg_dma_size = ACP_HS_TX_DMA_SIZE;
>> + acp_fifo_addr = ACP_SRAM_PTE_OFFSET +
>> + HS_PB_FIFO_ADDR_OFFSET;
>> + reg_fifo_addr = ACP_HS_TX_FIFOADDR;
>> + reg_fifo_size = ACP_HS_TX_FIFOSIZE;
>> + acp_writel(I2S_HS_TX_MEM_WINDOW_START,
>> + rtd->acp5x_base + ACP_HS_TX_RINGBUFADDR);
>> + break;
>> +
>> + case I2S_SP_INSTANCE:
>> + default:
>> + reg_dma_size = ACP_I2S_TX_DMA_SIZE;
>> + acp_fifo_addr = ACP_SRAM_PTE_OFFSET +
>> + SP_PB_FIFO_ADDR_OFFSET;
>> + reg_fifo_addr = ACP_I2S_TX_FIFOADDR;
>> + reg_fifo_size = ACP_I2S_TX_FIFOSIZE;
>> + acp_writel(I2S_SP_TX_MEM_WINDOW_START,
>> + rtd->acp5x_base + ACP_I2S_TX_RINGBUFADDR);
>> + }
>> + } else {
>> + switch (rtd->i2s_instance) {
>> + case I2S_HS_INSTANCE:
>> + reg_dma_size = ACP_HS_RX_DMA_SIZE;
>> + acp_fifo_addr = ACP_SRAM_PTE_OFFSET +
>> + HS_CAPT_FIFO_ADDR_OFFSET;
>> + reg_fifo_addr = ACP_HS_RX_FIFOADDR;
>> + reg_fifo_size = ACP_HS_RX_FIFOSIZE;
>> + acp_writel(I2S_HS_RX_MEM_WINDOW_START,
>> + rtd->acp5x_base + ACP_HS_RX_RINGBUFADDR);
>> + break;
>> +
>> + case I2S_SP_INSTANCE:
>> + default:
>> + reg_dma_size = ACP_I2S_RX_DMA_SIZE;
>> + acp_fifo_addr = ACP_SRAM_PTE_OFFSET +
>> + SP_CAPT_FIFO_ADDR_OFFSET;
>> + reg_fifo_addr = ACP_I2S_RX_FIFOADDR;
>> + reg_fifo_size = ACP_I2S_RX_FIFOSIZE;
>> + acp_writel(I2S_SP_RX_MEM_WINDOW_START,
>> + rtd->acp5x_base + ACP_I2S_RX_RINGBUFADDR);
>> + }
>> + }
>> + acp_writel(DMA_SIZE, rtd->acp5x_base + reg_dma_size);
>> + acp_writel(acp_fifo_addr, rtd->acp5x_base + reg_fifo_addr);
>> + acp_writel(FIFO_SIZE, rtd->acp5x_base + reg_fifo_size);
>> + acp_writel(BIT(I2S_RX_THRESHOLD) | BIT(HS_RX_THRESHOLD)
>> + | BIT(I2S_TX_THRESHOLD) | BIT(HS_TX_THRESHOLD),
>> + rtd->acp5x_base + ACP_EXTERNAL_INTR_CNTL);
>> +}
>> +
>
>> +static int acp5x_dma_hw_params(struct snd_soc_component *component,
>> + struct snd_pcm_substream *substream,
>> + struct snd_pcm_hw_params *params)
>> +{
>> + struct i2s_stream_instance *rtd;
>> + struct snd_soc_pcm_runtime *prtd;
>> + struct snd_soc_card *card;
>> + struct acp5x_platform_info *pinfo;
>> + struct i2s_dev_data *adata;
>> + u64 size;
>> +
>> + prtd = asoc_substream_to_rtd(substream);
>> + card = prtd->card;
>> + pinfo = snd_soc_card_get_drvdata(card);
>> + adata = dev_get_drvdata(component->dev);
>> + rtd = substream->runtime->private_data;
>> +
>> + if (!rtd)
>> + return -EINVAL;
>> +
>> + if (pinfo) {
>> + if (substream->stream == SNDRV_PCM_STREAM_PLAYBACK) {
>> + rtd->i2s_instance = pinfo->play_i2s_instance;
>> + switch (rtd->i2s_instance) {
>> + case I2S_HS_INSTANCE:
>> + adata->play_stream = substream;
>> + break;
>> + case I2S_SP_INSTANCE:
>> + default:
>> + adata->i2ssp_play_stream = substream;
>> + }
>> + } else {
>> + rtd->i2s_instance = pinfo->cap_i2s_instance;
>> + switch (rtd->i2s_instance) {
>> + case I2S_HS_INSTANCE:
>> + adata->capture_stream = substream;
>> + break;
>> + case I2S_SP_INSTANCE:
>> + default:
>> + adata->i2ssp_capture_stream = substream;
>> + }
>> + }
>> + } else {
>> + pr_err("pinfo failed\n");
>
> that seems like a rather useless message. if you want a log at least use dev_err(component->dev
will fix it and post the new version.
>
>> + }
>> + size = params_buffer_bytes(params);
>> + rtd->dma_addr = substream->dma_buffer.addr;
>> + rtd->num_pages = (PAGE_ALIGN(size) >> PAGE_SHIFT);
>> + config_acp5x_dma(rtd, substream->stream);
>> + return 0;
>> +}
>> +
More information about the Alsa-devel
mailing list