[PATCH v2 08/12] ASoC: arizona-jack: convert into a helper library for codec drivers

[Andy Shevchenko]

On Sun, Jan 17, 2021 at 6:06 PM Hans de Goede <hdegoede at redhat.com> wrote:
>
> Convert the arizona extcon driver into a helper library for direct use
> from the arizona codec-drivers, rather then being bound to a separate
> MFD cell.
>
> Note the probe (and remove) sequence is split into 2 parts:
>
> 1. The arizona_jack_codec_dev_probe() function inits a bunch of
> jack-detect specific variables in struct arizona_priv and tries to get
> a number of resources where getting them may fail with -EPROBE_DEFER.
>
> 2. Then once the machine driver has create a snd_sock_jack through
> snd_soc_card_jack_new() it calls snd_soc_component_set_jack() on
> the codec component, which will call the new arizona_jack_set_jack(),
> which sets up jack-detection and requests the IRQs.
>
> This split is necessary, because the IRQ handlers need access to the
> arizona->dapm pointer and the snd_sock_jack which are not available
> when the codec-driver's probe function runs.
>
> Note this requires that machine-drivers for codecs which are converted
> to use the new helper functions from arizona-jack.c are modified to
> create a snd_soc_jack through snd_soc_card_jack_new() and register
> this jack with the codec through snd_soc_component_set_jack().

...

> +int arizona_jack_codec_dev_probe(struct arizona_priv *info, struct device *dev)
>  {
> -       struct arizona *arizona = dev_get_drvdata(pdev->dev.parent);
> +       struct arizona *arizona = info->arizona;
>         struct arizona_pdata *pdata = &arizona->pdata;

> +       int ret, mode;
>
>         if (!dev_get_platdata(arizona->dev))
> -               arizona_extcon_device_get_pdata(&pdev->dev, arizona);
> +               arizona_extcon_device_get_pdata(dev, arizona);
>
> -       info->micvdd = devm_regulator_get(&pdev->dev, "MICVDD");
> +       info->micvdd = devm_regulator_get(arizona->dev, "MICVDD");

I'm wondering if arizona->dev == dev here. if no, can this function
get a comment / kernel-doc explaining what dev is?

>         if (IS_ERR(info->micvdd)) {

>                 ret = PTR_ERR(info->micvdd);
>                 dev_err(arizona->dev, "Failed to get MICVDD: %d\n", ret);

Side note: at some point perhaps consider to use dev_err_probe() with
functions which may return deferred probe error code.

...

> +       info->edev = devm_extcon_dev_allocate(dev, arizona_cable);
>         if (IS_ERR(info->edev)) {
> -               dev_err(&pdev->dev, "failed to allocate extcon device\n");
> +               dev_err(arizona->dev, "failed to allocate extcon device\n");

Ditto about dev.

>                 return -ENOMEM;
>         }

...

> +               ret = devm_gpio_request_one(dev, arizona->pdata.hpdet_id_gpio,
>                                             GPIOF_OUT_INIT_LOW,
>                                             "HPDET");
>                 if (ret != 0) {
>                         dev_err(arizona->dev, "Failed to request GPIO%d: %d\n",
>                                 arizona->pdata.hpdet_id_gpio, ret);
> -                       goto err_gpio;
> +                       gpiod_put(info->micd_pol_gpio);

Perhaps move before dev_err() ?
Side comment: Do we need dev_err_probe() here?

> +                       return ret;
>                 }

-- 
With Best Regards,
Andy Shevchenko