[PATCH v2 1/4] ASoC: dt-bindings: stm32: i2s: add audio-graph-card port

[Rob Herring]

On Fri, Nov 26, 2021 at 11:25:27AM +0100, Olivier MOYSAN wrote:
> Hi Rob,
> 
> On 11/25/21 10:26 PM, Rob Herring wrote:
> > On Thu, 25 Nov 2021 15:40:50 +0100, Olivier Moysan wrote:
> > > The STM2 I2S DAI can be connected via the audio-graph-card.
> > > Add port entry into the bindings.
> > > 
> > > Signed-off-by: Olivier Moysan <olivier.moysan at foss.st.com>
> > > ---
> > >   Documentation/devicetree/bindings/sound/st,stm32-i2s.yaml | 5 +++++
> > >   1 file changed, 5 insertions(+)
> > > 
> > 
> > Running 'make dtbs_check' with the schema in this patch gives the
> > following warnings. Consider if they are expected or the schema is
> > incorrect. These may not be new warnings.
> > 
> > Note that it is not yet a requirement to have 0 warnings for dtbs_check.
> > This will change in the future.
> > 
> > Full log is available here: https://patchwork.ozlabs.org/patch/1559750
> > 
> > 
> > audio-controller at 4000b000: 'port' does not match any of the regexes: '^port@[0-9]', 'pinctrl-[0-9]+'
> > 	arch/arm/boot/dts/stm32mp157a-dk1.dt.yaml
> > 	arch/arm/boot/dts/stm32mp157c-dk2.dt.yaml
> > 
> 
> This warning is not a new one.
> 
> The i2s2 node in stm32mp15xx-dkx.dtsi would require the following binding:
> port:
> 	$ref: audio-graph-port.yaml#
> 	unevaluatedProperties: false
> 
> However the spi binding requires to introduce a unit address:
> patternProperties:
>   '^port@[0-9]':
>     $ref: audio-graph-port.yaml#
>     unevaluatedProperties: false
> 
> The warning can be removed by re-ordering the bindings patches in the serie,
> as "additionalProperties: true" makes the check more tolerant on extra
> properties.

That's never right.

> The patch "ASoC: dt-bindings: stm32: i2s: add audio-graph-card port" can
> even be merely dropped.
> So, I suggest to resend the serie without audio-graph-card patch.

Only if you aren't using audio-graph-card.

> 
> Does it sound too permissive to you ?

I think perhaps you need to combine the schemas into 1. Or you need to 
restructure your dtsi files such that you only add spi specific 
properties when spi mode is enabled and only add i2s specific properties 
when i2s mode is enabled. Or use the /delete-property/ directive.

Rob