[RFC PATCH 1/1] ASoC: jack: use gpiolib inversion flag for inverted gpios

[Tobias Schramm]

This commit changes the handling of jack gpios with ACTIVE_LOW logic.
The inversion flag is now passed down and transparently handled by the
legacy gpiolib.

Previously the level of a gpio was inverted manually inside
snd_soc_jack_gpio_detect and gpiolib ACTIVE_LOW flag was not set on the
gpio. This resulted in erroneous output in /dev/class/gpio/gpio*/active_low
and debug interfaces like /sys/kernel/debug/gpio where the gpio was
still listed as active high while jack status for that gpio actually
followed an active low logic.

Signed-off-by: Tobias Schramm <t.schramm at manjaro.org>
---
 sound/soc/soc-jack.c | 8 +++++---
 1 file changed, 5 insertions(+), 3 deletions(-)

diff --git a/sound/soc/soc-jack.c b/sound/soc/soc-jack.c
index b5748dcd490f..8c17cfdbb883 100644
--- a/sound/soc/soc-jack.c
+++ b/sound/soc/soc-jack.c
@@ -254,8 +254,6 @@ static void snd_soc_jack_gpio_detect(struct snd_soc_jack_gpio *gpio)
 	int report;
 
 	enable = gpiod_get_value_cansleep(gpio->desc);
-	if (gpio->invert)
-		enable = !enable;
 
 	if (enable)
 		report = gpio->report;
@@ -385,6 +383,10 @@ int snd_soc_jack_add_gpios(struct snd_soc_jack *jack, int count,
 			}
 		} else {
 			/* legacy GPIO number */
+			int flags = GPIOF_IN;
+
+			if (gpios[i].invert)
+				flags |= GPIOF_ACTIVE_LOW;
 			if (!gpio_is_valid(gpios[i].gpio)) {
 				dev_err(jack->card->dev,
 					"ASoC: Invalid gpio %d\n",
@@ -393,7 +395,7 @@ int snd_soc_jack_add_gpios(struct snd_soc_jack *jack, int count,
 				goto undo;
 			}
 
-			ret = gpio_request_one(gpios[i].gpio, GPIOF_IN,
+			ret = gpio_request_one(gpios[i].gpio, flags,
 					       gpios[i].name);
 			if (ret)
 				goto undo;
-- 
2.24.1