[PATCH] sound: usb: pcm: fix incorrect power state when playing sound after PM_AUTO suspend
Macpaul Lin
macpaul.lin at mediatek.com
Wed Jun 3 14:39:24 CEST 2020
On Wed, 2020-06-03 at 10:45 +0200, Takashi Iwai wrote:
> On Wed, 03 Jun 2020 08:54:51 +0200,
> Takashi Iwai wrote:
> >
> > On Wed, 03 Jun 2020 08:28:09 +0200,
> > Takashi Iwai wrote:
> > >
> > > And, the most suspicious case is the last one,
> > > chip->num_suspended-intf. It means that the device has multiple
> > > USB interfaces and they went to suspend, while the resume isn't
> > > performed for the all suspended interfaces in return.
> >
> > If this is the cause, a patch like below might help.
> > It gets/puts the all assigned interfaced instead of only the primary
> > one.
>
> ... and considering of the problem again, rather the patch below might
> be the right answer. Now the driver tries to remember at which state
> it entered into the system-suspend. Upon resume, in return, when the
> state reaches back to that point, set the card state to D0.
>
> The previous patch can be applied on the top, too, and it might be
> worth to apply both.
>
> Let me know if any of those actually helps.
>
>
> Takashi
Thanks for your response so quickly.
I've just test this patch since it looks like enough for the issue.
This patch worked since the flag system_suspend will be set at the same
time when power state has been changed. I have 2 interface with the head
set. But actually the problem happened when primary one is suspended.
So I didn't test the earlier patch "suspend all interface instead of
only the primary one."
Will you resend this patch officially later? I think this solution is
required to send to stable, too. It's better to have it for other stable
kernel versions include android's.
> ---
> diff --git a/sound/usb/card.c b/sound/usb/card.c
> --- a/sound/usb/card.c
> +++ b/sound/usb/card.c
> @@ -843,9 +843,6 @@ static int usb_audio_suspend(struct usb_interface *intf, pm_message_t message)
> if (chip == (void *)-1L)
> return 0;
>
> - chip->autosuspended = !!PMSG_IS_AUTO(message);
> - if (!chip->autosuspended)
> - snd_power_change_state(chip->card, SNDRV_CTL_POWER_D3hot);
> if (!chip->num_suspended_intf++) {
> list_for_each_entry(as, &chip->pcm_list, list) {
> snd_usb_pcm_suspend(as);
> @@ -858,6 +855,11 @@ static int usb_audio_suspend(struct usb_interface *intf, pm_message_t message)
> snd_usb_mixer_suspend(mixer);
> }
>
> + if (!PMSG_IS_AUTO(message) && !chip->system_suspend) {
> + snd_power_change_state(chip->card, SNDRV_CTL_POWER_D3hot);
> + chip->system_suspend = chip->num_suspended_intf;
> + }
> +
> return 0;
> }
>
> @@ -871,10 +873,10 @@ static int __usb_audio_resume(struct usb_interface *intf, bool reset_resume)
>
> if (chip == (void *)-1L)
> return 0;
> - if (--chip->num_suspended_intf)
> - return 0;
>
> atomic_inc(&chip->active); /* avoid autopm */
> + if (chip->num_suspended_intf > 1)
> + goto out;
>
> list_for_each_entry(as, &chip->pcm_list, list) {
> err = snd_usb_pcm_resume(as);
> @@ -896,9 +898,12 @@ static int __usb_audio_resume(struct usb_interface *intf, bool reset_resume)
> snd_usbmidi_resume(p);
> }
>
> - if (!chip->autosuspended)
> + out:
> + if (chip->num_suspended_intf == chip->system_suspend) {
> snd_power_change_state(chip->card, SNDRV_CTL_POWER_D0);
> - chip->autosuspended = 0;
> + chip->system_suspend = 0;
> + }
> + chip->num_suspended_intf--;
>
> err_out:
> atomic_dec(&chip->active); /* allow autopm after this point */
> diff --git a/sound/usb/usbaudio.h b/sound/usb/usbaudio.h
> index 1c892c7f14d7..e0ebfb25fbd5 100644
> --- a/sound/usb/usbaudio.h
> +++ b/sound/usb/usbaudio.h
> @@ -26,7 +26,7 @@ struct snd_usb_audio {
> struct usb_interface *pm_intf;
> u32 usb_id;
> struct mutex mutex;
> - unsigned int autosuspended:1;
> + unsigned int system_suspend;
> atomic_t active;
> atomic_t shutdown;
> atomic_t usage_count;
>
> _______________________________________________
Thank you very much!
Best regards,
Macpaul Lin
More information about the Alsa-devel
mailing list