[alsa-devel] [PATCH v2 2/2] ASoC: dt-bindings: add bindings for AK4118 transceiver

[Rob Herring]

On Wed, Nov 14, 2018 at 01:16:42PM +0100, Clément Péron wrote:
> Document the bindings for AK4118 S/PDIF transceiver
> 
> Signed-off-by: Clément Péron <peron.clem at gmail.com>
> ---
>  .../devicetree/bindings/sound/ak4118.txt      | 22 +++++++++++++++++++
>  1 file changed, 22 insertions(+)
>  create mode 100644 Documentation/devicetree/bindings/sound/ak4118.txt
> 
> diff --git a/Documentation/devicetree/bindings/sound/ak4118.txt b/Documentation/devicetree/bindings/sound/ak4118.txt
> new file mode 100644
> index 000000000000..6e11a2f7404c
> --- /dev/null
> +++ b/Documentation/devicetree/bindings/sound/ak4118.txt
> @@ -0,0 +1,22 @@
> +AK4118 S/PDIF transceiver
> +
> +This device supports I2C mode.
> +
> +Required properties:
> +
> +- compatible : "asahi-kasei,ak4118"
> +- reg : The I2C address of the device for I2C
> +- reset-gpios: A GPIO specifier for the reset pin
> +- irq-gpios: A GPIO specifier for the IRQ pin

This should use 'interrupts' instead.

> +
> +Example:
> +
> +&i2c {
> +	ak4118: ak4118 at 13 {

spdif at 13 ? Node names should be based on the class of device, but 
there's not really one defined for this.

> +		#sound-dai-cells = <0>;
> +		compatible = "asahi-kasei,ak4118";
> +		reg = <0x13>;
> +		reset-gpios = <&gpio 0 GPIO_ACTIVE_LOW>
> +		irq-gpios = <&gpio 1 GPIO_ACTIVE_HIGH>;
> +	};
> +};
> -- 
> 2.19.1
>