[alsa-devel] [PATCH 3/5] media: i2c: Add TDA1997x HDMI receiver driver

[Tim Harvey]

On Wed, Nov 15, 2017 at 7:52 AM, Rob Herring <robh at kernel.org> wrote:
> On Thu, Nov 09, 2017 at 10:45:34AM -0800, Tim Harvey wrote:
>> Add support for the TDA1997x HDMI receivers.
>>
>> Cc: Hans Verkuil <hverkuil at xs4all.nl>
>> Signed-off-by: Tim Harvey <tharvey at gateworks.com>
>> ---
>> v3:
>>  - use V4L2_DV_BT_FRAME_WIDTH/HEIGHT macros
>>  - fixed missing break
>>  - use only hdmi_infoframe_log for infoframe logging
>>  - simplify tda1997x_s_stream error handling
>>  - add delayed work proc to handle hotplug enable/disable
>>  - fix set_edid (disable HPD before writing, enable after)
>>  - remove enabling edid by default
>>  - initialize timings
>>  - take quant range into account in colorspace conversion
>>  - remove vendor/product tracking (we provide this in log_status via infoframes)
>>  - add v4l_controls
>>  - add more detail to log_status
>>  - calculate vhref generator timings
>>  - timing detection fixes (rounding errors, hswidth errors)
>>  - rename configure_input/configure_conv functions
>>
>> v2:
>>  - implement dv timings enum/cap
>>  - remove deprecated g_mbus_config op
>>  - fix dv_query_timings
>>  - add EDID get/set handling
>>  - remove max-pixel-rate support
>>  - add audio codec DAI support
>>  - change audio bindings
>> ---
>>  drivers/media/i2c/Kconfig            |    9 +
>>  drivers/media/i2c/Makefile           |    1 +
>>  drivers/media/i2c/tda1997x.c         | 3485 ++++++++++++++++++++++++++++++++++
>>  include/dt-bindings/media/tda1997x.h |   78 +
>
> This belongs with the binding documentation patch.
>

Rob,

Thanks - missed that. I will move it for v4.

Regarding your previous comment to the v2 series:
> The rest of the binding looks fine, but I have some reservations about
> this. I think this should be common probably. There's been a few
> bindings for display recently that deal with the interface format. Maybe
> some vendor property is needed here to map a standard interface format
> back to pin configuration.

I take it this is not an 'Ack' for the bindings?

Which did you feel should be made common? I admit I was surprised
there wasn't a common binding for audio bus format (i2s|spdif) but if
you were referring to the video data that would probably be much more
complicated.

I was hoping one of the media/driver maintainers would respond to your
comment with thoughts as I'm not familiar with a very wide variety of
receivers.

Best regards,

Tim