[alsa-devel] [PATCH v4] ASoC: ak4613: call dummy write for PW_MGMT1/3 when Playback

[Kuninori Morimoto]

From: Kuninori Morimoto <kuninori.morimoto.gx at renesas.com>

Power Down Release Command (PMVR, PMDAC, RSTN, PMDA1-PMDA6)
which are located on PW_MGMT1 / PW_MGMT3 register must be
write again after at least 5 LRCK cycle or later on each command.
Otherwise, Playback volume will be 0dB.
Basically, it should be

	1.   PowerDownRelease by Power Management1 <= call 1.x after 5LRCK
	1.x  Dummy write      to Power Management1
	2.   PowerDownRelease by Power Management3 <= call 2.x after 5LRCK
	2.x  Dummy write      to Power Management3

To avoid too many dummy write, this patch is merging these.

	1.   PowerDownRelease by Power Management1
	2.   PowerDownRelease by Power Management3   <= call after 5LRCK
	2.x  Dummy write      to Power Management1/3 <= merge dummy write

This patch adds dummy write when Playback Start timing.

Tested-by: Hiroyuki Yokoyama <hiroyuki.yokoyama.vx at renesas.com>
Signed-off-by: Kuninori Morimoto <kuninori.morimoto.gx at renesas.com>
---
v3 -> v4

 - use schedule_work() instead of schedule_delayed_work()

 sound/soc/codecs/ak4613.c | 60 +++++++++++++++++++++++++++++++++++++++++++++++
 1 file changed, 60 insertions(+)

diff --git a/sound/soc/codecs/ak4613.c b/sound/soc/codecs/ak4613.c
index ee9e822..8d2c90b 100644
--- a/sound/soc/codecs/ak4613.c
+++ b/sound/soc/codecs/ak4613.c
@@ -15,6 +15,7 @@
  */
 
 #include <linux/clk.h>
+#include <linux/delay.h>
 #include <linux/i2c.h>
 #include <linux/slab.h>
 #include <linux/of_device.h>
@@ -95,6 +96,9 @@ struct ak4613_priv {
 	struct mutex lock;
 	const struct ak4613_interface *iface;
 	struct snd_pcm_hw_constraint_list constraint;
+	struct work_struct dummy_write_work;
+	struct snd_soc_component *component;
+	unsigned int rate;
 	unsigned int sysclk;
 
 	unsigned int fmt;
@@ -392,6 +396,7 @@ static int ak4613_dai_hw_params(struct snd_pcm_substream *substream,
 	default:
 		return -EINVAL;
 	}
+	priv->rate = rate;
 
 	/*
 	 * FIXME
@@ -467,11 +472,65 @@ static int ak4613_set_bias_level(struct snd_soc_component *component,
 	return 0;
 }
 
+static void ak4613_dummy_write(struct work_struct *work)
+{
+	struct ak4613_priv *priv = container_of(work,
+						struct ak4613_priv,
+						dummy_write_work);
+	struct snd_soc_component *component = priv->component;
+	unsigned int mgmt1;
+	unsigned int mgmt3;
+
+	/* wait 5 LR clocks */
+	udelay(5000000 / priv->rate);
+
+	snd_soc_component_read(component, PW_MGMT1, &mgmt1);
+	snd_soc_component_read(component, PW_MGMT3, &mgmt3);
+
+	snd_soc_component_write(component, PW_MGMT1, mgmt1);
+	snd_soc_component_write(component, PW_MGMT3, mgmt3);
+}
+
+static int ak4613_dai_trigger(struct snd_pcm_substream *substream, int cmd,
+			      struct snd_soc_dai *dai)
+{
+	struct snd_soc_codec *codec = dai->codec;
+	struct ak4613_priv *priv = snd_soc_codec_get_drvdata(codec);
+
+	/*
+	 * FIXME
+	 *
+	 * PW_MGMT1 / PW_MGMT3 needs dummy write at least after 5 LR clocks
+	 * from Power Down Release. Otherwise, Playback volume will be 0dB.
+	 * To avoid complex multiple delay/dummy_write method from
+	 * ak4613_set_bias_level() / SND_SOC_DAPM_DAC_E("DACx", ...),
+	 * call it once here.
+	 *
+	 * But, unfortunately, we can't "write" here because here is atomic
+	 * context (It uses I2C access for write).
+	 * Thus, use delayed work with 0 delay to switch to normal context
+	 * immediately, and wait 5 LR clocks and do dummy_write there.
+	 */
+
+	if ((cmd != SNDRV_PCM_TRIGGER_START) &&
+	    (cmd != SNDRV_PCM_TRIGGER_RESUME))
+		return 0;
+
+	if (substream->stream != SNDRV_PCM_STREAM_PLAYBACK)
+		return  0;
+
+	priv->component = &codec->component;
+	schedule_work(&priv->dummy_write_work);
+
+	return 0;
+}
+
 static const struct snd_soc_dai_ops ak4613_dai_ops = {
 	.startup	= ak4613_dai_startup,
 	.shutdown	= ak4613_dai_shutdown,
 	.set_sysclk	= ak4613_dai_set_sysclk,
 	.set_fmt	= ak4613_dai_set_fmt,
+	.trigger	= ak4613_dai_trigger,
 	.hw_params	= ak4613_dai_hw_params,
 };
 
@@ -591,6 +650,7 @@ static int ak4613_i2c_probe(struct i2c_client *i2c,
 	priv->iface		= NULL;
 	priv->cnt		= 0;
 	priv->sysclk		= 0;
+	INIT_WORK(&priv->dummy_write_work, ak4613_dummy_write);
 
 	mutex_init(&priv->lock);
 
-- 
1.9.1