[alsa-devel] [PATCH 0/6] ASoC: sgtl5000: fix use of regulators and internal LDO

[Eric Nelson]

Thanks for taking this up Clemens.

On 06/07/2016 01:14 AM, Clemens Gruber wrote:
> This patch set addresses a structural problem in the handling of
> regulators for VDDIO, VDDA, and VDDD in the SGTL5000 driver.
> 
> The first two of these power rails must be powered on prior to any I2C
> communication, and yet the regulators were tied to the codec, which is
> instantiated only after a fair amount of I2C communication takes place.
> 
> In other words, these regulators could never have function, and we can
> surmise that no user of this driver has switched power supply rails
> connected to them.
> 
> The third power rail (VDDD) can be derived internally (by using I2C
> registers) though the data sheet says that if an external VDDD is used,
> it should be enabled before MCLK is started and I2C activity begins.
> 
> [I rebased Eric's patches from Feb 2015, fixed a few warnings, URLs,
>  etc. and squashed two patches into one. - Clemens]
> 

Thanks also for fixing up my e-mail address (since I'm no longer at
Boundary Devices).

> Clemens Gruber (1):
>   ASoC: sgtl5000: Remove misleading comment
> 
> Eric Nelson (5):
>   ASoC: sgtl5000: Fix regulator support
>   ASoC: sgtl5000: Write all default registers
>   ASoC: sgtl5000: Initialize CHIP_ANA_POWER to power-on defaults
>   ASoC: sgtl5000: Disable internal PLL early
>   ASoC: sgtl5000: Do not disable regulators in SND_SOC_BIAS_OFF
> 
>  sound/soc/codecs/sgtl5000.c | 421 +++++++++++---------------------------------
>  sound/soc/codecs/sgtl5000.h |   2 +
>  2 files changed, 102 insertions(+), 321 deletions(-)
>