[alsa-devel] [PATCH] ASoC: pcm512x: Remove hardcoding of pll-lock to GPIO4
Howard Mitchell
hm at hmbedded.co.uk
Tue Mar 24 11:10:35 CET 2015
On 24/03/15 07:52, Peter Rosin wrote:
> Howard Mitchell wrote:
>> Currently GPIO4 is hardcoded to output the pll-lock signal.
>> Unfortunately this is after the pll-out GPIO is configured which
>> is selectable in the device tree. Therefore it is not possible to
>> use GPIO4 for pll-out. Therefore this patch removes the
>> configuration of GPIO4.
> Howard, thanks for picking up my laundry!
No problem. It was pretty quick and easy to redo from my previous patch
anyway.
> Is master mode working for you otherwise? Have you seen any sign
> of bad dividers for the various clocks, or anything like that?
Not so far. I've run though all the sampling rates from 44.1KHz to
192KHz with a 24.576MHz input clock and they all sounded ok. I haven't
done the maths and checked every single divider setting but I think I
would have heard if something wasn't quite right.
> Regarding the pin configuration, I suppose the cleanest approach
> would be to implement it as a pin control driver? Then you could
> also expose the pins as gpios and select the pin functions in a more
> standard way, right? I wouldn't know where to start with that
> though. I have the feeling that it would also mean that there would
> have to be a mfd driver for the chip???
Yes that would allow userspace access as well. I guess a good place to
start would be one of the I2C gpio expanders:
.../drivers_/_gpio_/_gpio-pca953x.c for instance.
> However, there is the issue that we don't need anything more from
> the chip, so we're happy with the driver as is (assuming the overclocking
> patch goes in as planned for 4.1).
On our board the additional gpios are not even tracked out so the driver
is fine as is for now. For the future we have discussed the possibility
of providing two master clock oscillators to avoid using the pll
altogether. In this case one of the gpios could be used for switching.
- Howard
More information about the Alsa-devel
mailing list