[alsa-devel] [PATCH 0/7] ASoC:davinci-mcasp: bc polarity fix and proper format support

[Peter Ujfalusi]

Hi Daniel,

On 04/04/2014 04:24 PM, Daniel Mack wrote:
> Hi Peter,
> 
> On 04/04/2014 01:31 PM, Peter Ujfalusi wrote:
>> The bit clock polarity has been configured incorrectly in the McASP driver for a
>> long time. IB_NF, NB_IF and IB_IF was not correct on the receive side since they
>> were selecting the same edge as we used for the tx.
>>
>> The driver only had support for DSP_B mode (and probably AC97, but I can not
>> test that). All other formats were broken (DSP_A, I2S, LEFT_J, etc).
> 
> Well, we're using this driver in I2S mode for a number of devices since
> a while, so the above statement is not entirely true :)

True, you could select I2S and ask for inverted frame sync with the old code.
However if you ask for DSP_A, LEFT_J, etc it was doing the wrong thing.

> The cleanups look sane, though. I can test them on AM33xx based hardware
> early next week. If you don't want to hold them off until then, no
> problem. I can also send fixups in case I spot a regression.

That would be great if you could also test these. It seams you have quite good
array of codecs available.

> Out of interest: which hardware and which dai format are you testing
> this with?

I have one AM335x board, one AM437x and one DRA7 where I can test right now. I
just go one OMAP-l138 board which I need to set up. It is good for legacy (non
DT boot) debugging.

> 
> 
> Thanks,
> Daniel
> 


-- 
Péter