[alsa-devel] [PATCH 6/6] ASoC: ux500: Use the first two AD slots for capture

[Lee Jones]

On Wed, 08 May 2013, Mark Brown wrote:

> On Wed, May 08, 2013 at 09:14:21AM +0200, Fabio Baltieri wrote:
> > Set AD_OUT1 and AD_OUT2, corresponding to LINL and LINR pins, as the
> > default input slots for the capture interfaces.
> 
> If these are routing specific analogue inputs to specific timeslots then
> this is routing that should be being exposed to DAPM as muxes, not hard
> coded in the middle of TDM slot configuration (which is both obscure and
> not what the TDM API is there for).  The TDM API should be purely about
> placing the timeslots for the audio interface on the bus.

Again, I think this patch is a valid bugfix. If the driver requires
refactoring, it should be done by someone else. That's not the purpose
of Fabio's role.

-- 
Lee Jones
Linaro ST-Ericsson Landing Team Lead
Linaro.org │ Open source software for ARM SoCs
Follow Linaro: Facebook | Twitter | Blog