[alsa-devel] [PATCH V3 2/3] ASoC: Samsung: I2S: Add quirks as driver data in I2S
Padmavathi Venna
padma.v at samsung.com
Wed Aug 7 10:45:21 CEST 2013
Samsung has different versions of I2S introduced in different
platforms. Each version has some new support added for multichannel,
secondary fifo, s/w reset control and internal mux for rclk src clk.
Each newly added change has a quirk. So this patch adds all the
required quirks as driver data and based on compatible string from
dtsi fetches the quirks.
Signed-off-by: Padmavathi Venna <padma.v at samsung.com>
---
.../devicetree/bindings/sound/samsung-i2s.txt | 21 +++---
sound/soc/samsung/i2s.c | 82 +++++++++++++-------
2 files changed, 64 insertions(+), 39 deletions(-)
diff --git a/Documentation/devicetree/bindings/sound/samsung-i2s.txt b/Documentation/devicetree/bindings/sound/samsung-i2s.txt
index 025e66b..b3f6443 100644
--- a/Documentation/devicetree/bindings/sound/samsung-i2s.txt
+++ b/Documentation/devicetree/bindings/sound/samsung-i2s.txt
@@ -2,7 +2,16 @@
Required SoC Specific Properties:
-- compatible : "samsung,i2s-v5"
+- compatible : should be one of the following.
+ - samsung,s3c6410-i2s: for 8/16/24bit stereo I2S. Previous versions
+ has only 8/16bit support.
+ - samsung,s3c6410-i2sv4: for 8/16/24bit multichannel(5.1 channel) I2S.
+ Introduced in s3c6410. This also applicable for s5p64x0 platforms.
+ - samsung,s5pc100-i2s: for 8/16/24bit multichannel(5.1 channel) I2S
+ with secondary fifo and s/w reset control.
+ - samsung,s5pv210-i2s: for 8/16/24bit multichannel(5.1) I2S with
+ secondary fifo, s/w reset control and internal mux for root clk src.
+
- reg: physical base address of the controller and length of memory mapped
region.
- dmas: list of DMA controller phandle and DMA request line ordered pairs.
@@ -21,13 +30,6 @@ Required SoC Specific Properties:
Optional SoC Specific Properties:
-- samsung,supports-6ch: If the I2S Primary sound source has 5.1 Channel
- support, this flag is enabled.
-- samsung,supports-rstclr: This flag should be set if I2S software reset bit
- control is required. When this flag is set I2S software reset bit will be
- enabled or disabled based on need.
-- samsung,supports-secdai:If I2S block has a secondary FIFO and internal DMA,
- then this flag is enabled.
- samsung,idma-addr: Internal DMA register base address of the audio
sub system(used in secondary sound source).
- pinctrl-0: Should specify pin control groups used for this controller.
@@ -46,9 +48,6 @@ i2s0: i2s at 03830000 {
<&clock_audss EXYNOS_I2S_BUS>,
<&clock_audss EXYNOS_SCLK_I2S>;
clock-names = "iis", "i2s_opclk0", "i2s_opclk1";
- samsung,supports-6ch;
- samsung,supports-rstclr;
- samsung,supports-secdai;
samsung,idma-addr = <0x03000000>;
pinctrl-names = "default";
pinctrl-0 = <&i2s0_bus>;
diff --git a/sound/soc/samsung/i2s.c b/sound/soc/samsung/i2s.c
index 47e08dd..8a5504c 100644
--- a/sound/soc/samsung/i2s.c
+++ b/sound/soc/samsung/i2s.c
@@ -40,6 +40,7 @@ enum samsung_dai_type {
struct samsung_i2s_dai_data {
int dai_type;
+ u32 quirks;
};
struct i2s_dai {
@@ -1032,18 +1033,18 @@ static struct i2s_dai *i2s_alloc_dai(struct platform_device *pdev, bool sec)
static const struct of_device_id exynos_i2s_match[];
-static inline int samsung_i2s_get_driver_data(struct platform_device *pdev)
+static inline struct samsung_i2s_dai_data *samsung_i2s_get_driver_data(
+ struct platform_device *pdev)
{
#ifdef CONFIG_OF
- struct samsung_i2s_dai_data *data;
if (pdev->dev.of_node) {
const struct of_device_id *match;
match = of_match_node(exynos_i2s_match, pdev->dev.of_node);
- data = (struct samsung_i2s_dai_data *) match->data;
- return data->dai_type;
+ return (struct samsung_i2s_dai_data *) match->data;
} else
#endif
- return platform_get_device_id(pdev)->driver_data;
+ return (struct samsung_i2s_dai_data *)
+ platform_get_device_id(pdev)->driver_data;
}
#ifdef CONFIG_PM_RUNTIME
@@ -1074,13 +1075,13 @@ static int samsung_i2s_probe(struct platform_device *pdev)
struct resource *res;
u32 regs_base, quirks = 0, idma_addr = 0;
struct device_node *np = pdev->dev.of_node;
- enum samsung_dai_type samsung_dai_type;
+ struct samsung_i2s_dai_data *i2s_dai_data;
int ret = 0;
/* Call during Seconday interface registration */
- samsung_dai_type = samsung_i2s_get_driver_data(pdev);
+ i2s_dai_data = samsung_i2s_get_driver_data(pdev);
- if (samsung_dai_type == TYPE_SEC) {
+ if (i2s_dai_data->dai_type == TYPE_SEC) {
sec_dai = dev_get_drvdata(&pdev->dev);
if (!sec_dai) {
dev_err(&pdev->dev, "Unable to get drvdata\n");
@@ -1129,15 +1130,7 @@ static int samsung_i2s_probe(struct platform_device *pdev)
idma_addr = i2s_cfg->idma_addr;
}
} else {
- if (of_find_property(np, "samsung,supports-6ch", NULL))
- quirks |= QUIRK_PRI_6CHAN;
-
- if (of_find_property(np, "samsung,supports-secdai", NULL))
- quirks |= QUIRK_SEC_DAI;
-
- if (of_find_property(np, "samsung,supports-rstclr", NULL))
- quirks |= QUIRK_NEED_RSTCLR;
-
+ quirks = i2s_dai_data->quirks;
if (of_property_read_u32(np, "samsung,idma-addr",
&idma_addr)) {
if (quirks & QUIRK_SEC_DAI) {
@@ -1250,27 +1243,60 @@ static int samsung_i2s_remove(struct platform_device *pdev)
return 0;
}
+static struct samsung_i2s_dai_data i2sv3_dai_type = {
+ .dai_type = TYPE_PRI,
+ .quirks = QUIRK_NO_MUXPSR,
+};
+
+static struct samsung_i2s_dai_data i2sv4_dai_type = {
+ .dai_type = TYPE_PRI,
+ .quirks = QUIRK_PRI_6CHAN | QUIRK_NO_MUXPSR,
+};
+
+static struct samsung_i2s_dai_data i2sv5_c100_dai_type = {
+ .dai_type = TYPE_PRI,
+ .quirks = QUIRK_PRI_6CHAN | QUIRK_NO_MUXPSR | QUIRK_SEC_DAI |
+ QUIRK_NEED_RSTCLR,
+};
+
+static struct samsung_i2s_dai_data i2sv5_dai_type = {
+ .dai_type = TYPE_PRI,
+ .quirks = QUIRK_PRI_6CHAN | QUIRK_SEC_DAI | QUIRK_NEED_RSTCLR,
+};
+
+static struct samsung_i2s_dai_data samsung_dai_type_sec = {
+ .dai_type = TYPE_SEC,
+};
+
static struct platform_device_id samsung_i2s_driver_ids[] = {
{
- .name = "samsung-i2s",
- .driver_data = TYPE_PRI,
+ .name = "samsung,s3c6410-i2s",
+ .driver_data = (kernel_ulong_t)&i2sv3_dai_type,
+ }, {
+ .name = "samsung,s3c6410-i2s-multi",
+ .driver_data = (kernel_ulong_t)&i2sv4_dai_type,
+ }, {
+ .name = "samsung,s5pc100-i2s",
+ .driver_data = (kernel_ulong_t)&i2sv5_c100_dai_type,
}, {
- .name = "samsung-i2s-sec",
- .driver_data = TYPE_SEC,
+ .name = "samsung,s5pv210-i2s",
+ .driver_data = (kernel_ulong_t)&i2sv5_dai_type,
+ }, {
+ .name = "samsung-i2s-sec",
+ .driver_data = (kernel_ulong_t)&samsung_dai_type_sec,
},
{},
};
MODULE_DEVICE_TABLE(platform, samsung_i2s_driver_ids);
#ifdef CONFIG_OF
-static struct samsung_i2s_dai_data samsung_i2s_dai_data_array[] = {
- [TYPE_PRI] = { TYPE_PRI },
- [TYPE_SEC] = { TYPE_SEC },
-};
-
static const struct of_device_id exynos_i2s_match[] = {
- { .compatible = "samsung,i2s-v5",
- .data = &samsung_i2s_dai_data_array[TYPE_PRI],
+ {
+ .compatible = "samsung,s3c6410-i2s",
+ .data = &i2sv3_dai_type,
+ }, {
+ .compatible = "samsung,s5pv210-i2s",
+ .data = &i2sv5_dai_type,
},
{},
};
--
1.7.4.4
More information about the Alsa-devel
mailing list