[alsa-devel] [PATCH RFC 08/13] ASoC: kirkwood: add DAPM widgets for input and output routing
Russell King
rmk+kernel at arm.linux.org.uk
Sun Aug 4 21:29:04 CEST 2013
Add DAPM widgets for the audio unit inputs and outputs. The SPDIF
output route must only be used if the hardware actually supports it.
Signed-off-by: Russell King <rmk+kernel at arm.linux.org.uk>
---
sound/soc/kirkwood/kirkwood-i2s.c | 36 +++++++++++++++++++++++++++++++++++-
sound/soc/kirkwood/kirkwood.h | 1 +
2 files changed, 36 insertions(+), 1 deletions(-)
diff --git a/sound/soc/kirkwood/kirkwood-i2s.c b/sound/soc/kirkwood/kirkwood-i2s.c
index 84dd9b0..3d039c3 100644
--- a/sound/soc/kirkwood/kirkwood-i2s.c
+++ b/sound/soc/kirkwood/kirkwood-i2s.c
@@ -242,7 +242,7 @@ static int kirkwood_i2s_play_trigger(struct snd_pcm_substream *substream,
switch (cmd) {
case SNDRV_PCM_TRIGGER_START:
/* configure */
- ctl = priv->ctl_play;
+ ctl = priv->ctl_play & priv->ctl_play_mask;
value = ctl & ~KIRKWOOD_PLAYCTL_ENABLE_MASK;
writel(value, priv->io + KIRKWOOD_PLAYCTL);
@@ -360,12 +360,39 @@ static int kirkwood_i2s_trigger(struct snd_pcm_substream *substream, int cmd,
return 0;
}
+static int kirkwood_i2s_play_i2s(struct snd_soc_dapm_widget *w,
+ struct snd_kcontrol *ctl, int event)
+{
+ /* This works because the platform and cpu dai are the same dev */
+ struct kirkwood_dma_data *priv = snd_soc_platform_get_drvdata(w->platform);
+
+ if (SND_SOC_DAPM_EVENT_ON(event))
+ priv->ctl_play_mask |= KIRKWOOD_PLAYCTL_I2S_EN;
+ else
+ priv->ctl_play_mask &= ~KIRKWOOD_PLAYCTL_I2S_EN;
+
+ return 0;
+}
+
+static const struct snd_soc_dapm_widget widgets[] = {
+ /* These widget names come from the names from the functional spec */
+ SND_SOC_DAPM_AIF_OUT_E("i2sdo", "dma-tx",
+ 0, SND_SOC_NOPM, 0, 0, kirkwood_i2s_play_i2s,
+ SND_SOC_DAPM_PRE_PMU | SND_SOC_DAPM_POST_PMD),
+ SND_SOC_DAPM_AIF_IN("i2sdi", "dma-rx",
+ 0, SND_SOC_NOPM, 0, 0),
+};
+
static int kirkwood_i2s_probe(struct snd_soc_dai *dai)
{
struct kirkwood_dma_data *priv = snd_soc_dai_get_drvdata(dai);
unsigned long value;
unsigned int reg_data;
+ /* It appears that these can't be attached to the CPU DAI */
+ snd_soc_dapm_new_controls(&dai->platform->dapm,
+ widgets, ARRAY_SIZE(widgets));
+
/* put system in a "safe" state : */
/* disable audio interrupts */
writel(0xffffffff, priv->io + KIRKWOOD_INT_CAUSE);
@@ -383,6 +410,8 @@ static int kirkwood_i2s_probe(struct snd_soc_dai *dai)
reg_data |= 0x111D18;
writel(reg_data, priv->io + 0x1200);
+ priv->ctl_play_mask = ~KIRKWOOD_PLAYCTL_ENABLE_MASK;
+
/* disable playback/record */
value = readl(priv->io + KIRKWOOD_PLAYCTL);
value &= ~KIRKWOOD_PLAYCTL_ENABLE_MASK;
@@ -413,12 +442,14 @@ static struct snd_soc_dai_driver kirkwood_i2s_dai = {
.probe = kirkwood_i2s_probe,
.remove = kirkwood_i2s_remove,
.playback = {
+ .stream_name = "dma-tx",
.channels_min = 1,
.channels_max = 2,
.rates = KIRKWOOD_I2S_RATES,
.formats = KIRKWOOD_I2S_FORMATS,
},
.capture = {
+ .stream_name = "dma-rx",
.channels_min = 1,
.channels_max = 2,
.rates = KIRKWOOD_I2S_RATES,
@@ -431,6 +462,7 @@ static struct snd_soc_dai_driver kirkwood_i2s_dai_extclk = {
.probe = kirkwood_i2s_probe,
.remove = kirkwood_i2s_remove,
.playback = {
+ .stream_name = "dma-tx",
.channels_min = 1,
.channels_max = 2,
.rates = SNDRV_PCM_RATE_8000_192000 |
@@ -439,6 +471,7 @@ static struct snd_soc_dai_driver kirkwood_i2s_dai_extclk = {
.formats = KIRKWOOD_I2S_FORMATS,
},
.capture = {
+ .stream_name = "dma-rx",
.channels_min = 1,
.channels_max = 2,
.rates = SNDRV_PCM_RATE_8000_192000 |
@@ -534,6 +567,7 @@ static int kirkwood_i2s_dev_probe(struct platform_device *pdev)
goto err_platform;
}
return 0;
+
err_platform:
snd_soc_unregister_component(&pdev->dev);
err_component:
diff --git a/sound/soc/kirkwood/kirkwood.h b/sound/soc/kirkwood/kirkwood.h
index f8e1ccc..3b70876 100644
--- a/sound/soc/kirkwood/kirkwood.h
+++ b/sound/soc/kirkwood/kirkwood.h
@@ -132,6 +132,7 @@ struct kirkwood_dma_data {
void __iomem *io;
struct clk *clk;
struct clk *extclk;
+ uint32_t ctl_play_mask;
uint32_t ctl_play;
uint32_t ctl_rec;
struct snd_pcm_substream *substream_play;
--
1.7.4.4
More information about the Alsa-devel
mailing list