[alsa-devel] [PATCH 1/3] ASoC: omap-mcpdm: Replace legacy driver

[Liam Girdwood]

On 07/07/11 16:57, Mark Brown wrote:
> On Thu, Jul 07, 2011 at 03:27:50PM +0300, Peter Ujfalusi wrote:
> 
>> The current McPDM driver design is not suitable to support both
>> the ABE and Legacy DMA operating modes. Therefore remove most
> 
> In what way is it not suitable?

It cant support both the ABE and Legacy DMA modes without adding some unnecessary and complicated logic. My preference is 1 driver to support both modes of operation and this is the easiest way to do so (also keeping the maintenance easier too).

> 
>> +/*
>> + * Enables the transfer through the PDM interface to/from the Phoenix
>> + * codec by enabling the corresponding UP or DN channels.
>> + */
>> +static void omap_mcpdm_start(struct omap_mcpdm *mcpdm)
>> +{
>> +	u32 ctrl = omap_mcpdm_read(mcpdm, MCPDM_REG_CTRL);
>> +
>> +	ctrl |= (MCPDM_SW_DN_RST | MCPDM_SW_UP_RST);
>> +	omap_mcpdm_write(mcpdm, MCPDM_REG_CTRL, ctrl);
>> +
>> +	ctrl |= mcpdm->dn_channels | mcpdm->up_channels;
>> +	omap_mcpdm_write(mcpdm, MCPDM_REG_CTRL, ctrl);
>> +
>> +	ctrl &= ~(MCPDM_SW_DN_RST | MCPDM_SW_UP_RST);
>> +	omap_mcpdm_write(mcpdm, MCPDM_REG_CTRL, ctrl);
>> +}
> 
> Presumably this works with any PDM input/output?

Yes.

> 
>> +/* work to delay McPDM shutdown */
>> +static void playback_work(struct work_struct *work)
>> +{
>> +	struct omap_mcpdm *mcpdm = container_of(work,
>> +					struct omap_mcpdm, delayed_work.work);
>> +
>> +	if (!mcpdm->active && omap_mcpdm_active(mcpdm)) {
>> +		omap_mcpdm_stop(mcpdm);
>> +		omap_mcpdm_close_streams(mcpdm);
>> +	}
>> +
>> +	if (!omap_mcpdm_active(mcpdm))
>> +		pm_runtime_put_sync(mcpdm->dev);
>> +}
> 
> It occurs to me that it'd be much simpler to implement this by doing the
> cleanup in your runtime suspend callback, it looks like you're working
> around the pm_runtime framework rather than using it.  If you need to do
> some cleanup when the device goes idle and you can't do it within a
> framework designed to suspend the device when it goes idle then there's
> an issue there.
> 
> Alternatively, why is this deferred?

There are some power, clock and pop dependencies here between the CODEC, ABE and McPDM interface and this deferred work allows us to shutwdown McPDM (in a pop free manner) and satisfy the dependencies without causing a data abort and/or locking the ABE firmware.

Liam