[alsa-devel] [PATCH] maestro3: Fix hw volume on HP OmniBook
Ville Syrjälä
syrjala at sci.fi
Tue Jun 3 19:52:10 CEST 2008
maestro3: Fix hw volume on HP OmniBook
Make the hw volume buttons work correctly on some HP OmniBook laptops.
The original quirk was apparently applied a bit too early and it was
also lacking some critial register writes. This improved sequence was
discovered by trial and error (like the original sequence). Tested and
found working on OB500 and OB6000 laptops.
Signed-off-by: Ville Syrjala <syrjala at sci.fi>
---
sound/pci/maestro3.c | 42 +++++++++++++++++++++++++++---------------
1 file changed, 27 insertions(+), 15 deletions(-)
Index: linux-2.6.25.4/sound/pci/maestro3.c
===================================================================
--- linux-2.6.25.4.orig/sound/pci/maestro3.c
+++ linux-2.6.25.4/sound/pci/maestro3.c
@@ -2427,6 +2427,29 @@ snd_m3_amp_enable(struct snd_m3 *chip, i
outw(0xffff, io + GPIO_MASK);
}
+static void
+snd_m3_hv_init(struct snd_m3 *chip)
+{
+ unsigned long io = chip->iobase;
+ u16 val = GPI_VOL_DOWN | GPI_VOL_UP;
+
+ if (!chip->is_omnibook)
+ return;
+
+ /*
+ * Volume buttons on some HP OmniBook laptops
+ * require some GPIO magic to work correctly.
+ */
+ outw(0xffff, io + GPIO_MASK);
+ outw(0x0000, io + GPIO_DATA);
+
+ outw(~val, io + GPIO_MASK);
+ outw(inw(io + GPIO_DIRECTION) & ~val, io + GPIO_DIRECTION);
+ outw(val, io + GPIO_MASK);
+
+ outw(0xffff, io + GPIO_MASK);
+}
+
static int
snd_m3_chip_init(struct snd_m3 *chip)
{
@@ -2442,21 +2465,6 @@ snd_m3_chip_init(struct snd_m3 *chip)
DISABLE_LEGACY);
pci_write_config_word(pcidev, PCI_LEGACY_AUDIO_CTRL, w);
- if (chip->is_omnibook) {
- /*
- * Volume buttons on some HP OmniBook laptops don't work
- * correctly. This makes them work for the most part.
- *
- * Volume up and down buttons on the laptop side work.
- * Fn+cursor_up (volme up) works.
- * Fn+cursor_down (volume down) doesn't work.
- * Fn+F7 (mute) works acts as volume up.
- */
- outw(~(GPI_VOL_DOWN|GPI_VOL_UP), io + GPIO_MASK);
- outw(inw(io + GPIO_DIRECTION) & ~(GPI_VOL_DOWN|GPI_VOL_UP), io + GPIO_DIRECTION);
- outw((GPI_VOL_DOWN|GPI_VOL_UP), io + GPIO_DATA);
- outw(0xffff, io + GPIO_MASK);
- }
pci_read_config_dword(pcidev, PCI_ALLEGRO_CONFIG, &n);
n &= ~(HV_CTRL_ENABLE | REDUCED_DEBOUNCE | HV_BUTTON_FROM_GD);
n |= chip->hv_config;
@@ -2644,6 +2652,8 @@ static int m3_resume(struct pci_dev *pci
snd_m3_enable_ints(chip);
snd_m3_amp_enable(chip, 1);
+ snd_m3_hv_init(chip);
+
snd_power_change_state(card, SNDRV_CTL_POWER_D0);
return 0;
}
@@ -2783,6 +2793,8 @@ snd_m3_create(struct snd_card *card, str
snd_m3_amp_enable(chip, 1);
+ snd_m3_hv_init(chip);
+
tasklet_init(&chip->hwvol_tq, snd_m3_update_hw_volume, (unsigned long)chip);
if (request_irq(pci->irq, snd_m3_interrupt, IRQF_SHARED,
More information about the Alsa-devel
mailing list