rimage is not built by default, which can lead to disconnects and awful bugs when the memory layout changes. Add rimage build+install as default for xtensa scripts The BKM should be to rely on executing ./scripts/xtensa-build-all.sh [byt|cht|apl|cnl] instead of manual commands... Signed-off-by: Pierre-Louis Bossart <pierre-louis.bossart@linux.intel.com> --- scripts/xtensa-build-all.sh | 6 ++++++ 1 file changed, 6 insertions(+) diff --git a/scripts/xtensa-build-all.sh b/scripts/xtensa-build-all.sh index 227254f..35ff9d9 100755 --- a/scripts/xtensa-build-all.sh +++ b/scripts/xtensa-build-all.sh @@ -6,6 +6,12 @@ set -e pwd=`pwd` +# make sure rimage is built and aligned with code +./configure --enable-rimage +make +sudo make install + +# now build the firmware (depends on rimage) rm -fr src/arch/xtensa/*.ri SUPPORTED_PLATFORMS=(byt cht bdw hsw apl cnl) -- 2.14.1