Hi Daniel,

Compiled and running! So far so good! I haven't pushed the jack parameters more than I would usually though... I'm still at 16ms latency (Frame/period: 256 ; Sample Rate: 48000 ; Periods Buffer: 3). That was the minimum I could go with the previous driver, so I'll try to push it a bit tomorrow and see how it goes. Is there any particular testing you would like to see done?

Another thing, in your previous post, you asked to try the driver with other sound card. I have an Edirol UA-25Ex that never worked on this machine (I have the dredded EHCI USB port, it's the reason why I bought the FTU in the first place). The error I used to get while starting Jack in Full Duplex with this sound card was "Cannot submit datapipe for urb 0, error -28: not enough bandwidth"

But, "apparently".......now it works! I tried it not later than last week with Kernel 3.0 and it still wasn't working.

But with 3.2 and your patch, (and after running the FTU on the very same USB port), I got the UA-25Ex to work in full duplex for the first time ever.

I don't know if it is due to the new version of the kernel, or your patch, or something else, but this is huge because a lot of people used to have this problem with EHCI and USB 1 sound cards. (or may be it was simply fixed between 3.0 and 3.2 and I simply missed it!).

So the second question is: what do you think? Any info you would like to see posted here? (dmesg trace....anything else?).

Anyway, thanks a lot for everything :)

Aurélien

On Thu, Dec 8, 2011 at 7:38 PM, Daniel Mack zonque@gmail.com wrote:

Hi Aurélien,

On 12/08/2011 08:33 PM, Aurélien Leblond wrote:

...

I finally got some time to test this driver! I'm not sure I understand where to get Takashi's sound tree.

I tried to apply your patch against a clone of git://git.alsa-project.org/alsa-kmirror.git alsa-kmirror, but then GitCompile failed.

I then tried to use git://git.kernel.org/pub/scm/linux/kernel/git/tiwai/sound.git , but I'm not even sure what I'm pulling to be honest...

Would you mind just guiding me on how to prepare the source code?

No problem :)

Clone Linus' tree:

git://git.kernel.org/pub/scm/linux/kernel/git/torvalds/linux.git

Make a local branch and pull in Takashi's tree:

cd linux  git checkout -b alsa  git pull git://git.kernel.org/pub/scm/linux/kernel/git/tiwai/sound.git master

Make another branch on top of that

git checkout -b usbaudio

Then apply my patch(es). For the next round, just kill the local usbaudio branch again and start over:

git reset --hard  git checkout alsa  git branch -D usbaudio  git checkout -b usbaudio

Then apply the next round :)

...

Thanks in advance, and thanks for all the work you have already done!

No problem. I'm planning to continue work on this these days. It's just that I'm constantly distracted by other things :-/

Daniel