Re: [alsa-devel] Can someone verify support for "AzTech Sound Galaxy Nova 16 Extra II-3D - using AZT-2316/R Chipset - FCC-ID:I38-MMSN846" ?
Well, it didn't take long so here's the results : "sudo modprobe snd-sb8 port=0x220 irq=5 dma8=1" gave no errors, and "lsmod" later gave: Module Size Used by snd_sb8 9216 0 snd_sb8_dsp 12288 1 snd_sb8 snd_sb_common 17792 2 snd_sb8,snd_sb8_dsp snd_opl3_lib 11520 1 snd_sb8 snd_hwdep 9988 1 snd_opl3_lib snd_pcm_oss 44544 0 snd_pcm 79876 3 snd_sb8,snd_sb8_dsp,snd_pcm_oss snd_mixer_oss 17408 1 snd_pcm_oss snd_seq_dummy 4740 0 snd_seq_oss 32896 0 snd_seq_midi 9600 0 snd_rawmidi 25472 2 snd_sb8_dsp,snd_seq_midi snd_seq_midi_event 8448 2 snd_seq_oss,snd_seq_midi snd_seq 52592 6 snd_seq_dummy,snd_seq_oss,snd_seq_midi,snd_seq_midi_event snd_timer 23684 3 snd_opl3_lib,snd_pcm,snd_seq snd_seq_device 9100 6 snd_opl3_lib,snd_seq_dummy,snd_seq_oss,snd_seq_midi,snd_rawmidi,snd_seq snd 54020 13 snd_sb8,snd_sb8_dsp,snd_sb_common,snd_opl3_lib,snd_hwdep,snd_pcm_oss,snd_pcm,snd_mixer_oss,snd_seq_oss,snd_rawmidi,snd_seq,snd_timer,snd_seq_device soundcore 8672 1 snd snd_page_alloc 10888 1 snd_pcm nfs 240876 0 nfsd 218992 17 exportfs 6912 1 nfsd lockd 64904 3 nfs,nfsd sunrpc 161340 12 nfs,nfsd,lockd apm 22752 1 ppdev 10116 0 cpufreq_stats 7360 0 cpufreq_ondemand 9228 0 cpufreq_powersave 2688 0 freq_table 5792 2 cpufreq_stats,cpufreq_ondemand cpufreq_conservative 8200 0 cpufreq_userspace 5408 0 nls_iso8859_1 5120 1 nls_cp437 6784 1 vfat 14208 1 fat 53916 1 vfat ext2 66824 1 lp 12452 0 parport_pc 36388 1 parport 36936 3 ppdev,lp,parport_pc pcspkr 4224 0 ipv6 268704 8 tsdev 8768 0 evdev 11008 1 ext3 133128 1 jbd 59816 1 ext3 mbcache 9604 2 ext2,ext3 8139too 27648 0 ide_cd 32672 0 cdrom 37664 1 ide_cd ide_disk 17024 5 floppy 59524 0 ehci_hcd 34188 0 8139cp 25088 0 mii 6528 2 8139too,8139cp uhci_hcd 25360 0 usbcore 134280 3 ehci_hcd,uhci_hcd piix 10756 0 [permanent] generic 5124 0 [permanent] ata_generic 9092 0 libata 125720 1 ata_generic scsi_mod 142348 1 libata fbcon 42656 0 tileblit 3584 1 fbcon font 9216 1 fbcon bitblit 6912 1 fbcon softcursor 3200 1 bitblit vesafb 9220 0 capability 5896 0 commoncap 8192 1 capability
But when I try to play an ogg gxine crushes an xmms ignores, when trying an mp3 gxine again crushes and xmms gives the soundcard no configured error...
Just a recap: I verifyed using dos the settings (hwset and volset - default and save), and used the bios to set "IRQ 5" as "ISA Legacy".
I didn't use the jumper as I see no need since the epprom already does the job.
So I'm stuck, What do you think I should do now ? Ram Kromberg ramkromberg@mail.com
On 05/10/2007 10:57 PM, ramkromberg@mail.com wrote:
Just a recap: I verifyed using dos the settings (hwset and volset - default and save), and used the bios to set "IRQ 5" as "ISA Legacy".
I didn't use the jumper as I see no need since the epprom already does the job.
I don't understand what you mean here. You need to set the JMPCFG jumper to the EEPROM setting so that the card will configure itself at poweron using the values stored in its EEPROM and not wait for a driver to configure and enable it (which the Linux driver does not do).
Rene.
participants (2)
-
ramkrombergļ¼ mail.com
-
Rene Herman