I've been trying to get ALSA working with this laptop. So far the attached patch adds rear support to the existing 4930g model, and tries to add CLFE support. However, I haven't been able to get CLFE to work. I don't seem to get any audio through DACs/mixers other than the first two (front and rear).

I can assign the CLFE output (pin 0x16) to the front or rear DAC and hear the front audio through the CLFE speakers. I can also force the front DAC (0x02) or rear DAC (0x03) to use the CLFE stream and hear it through the front or rear speakers, so the audio is getting to the codec. But either DACs 0x04 and 0x05 aren't working, or their associated mixers (0x0e and 0x0f) aren't passing through the audio, or the OUT pins don't like selections above 1. I've checked that they're unmuted and that the volumes are turned up on both. I've also tried the 0x25->0x26 DAC/mixer auxiliary pathway, which doesn't work either.

Here's what the relevant NIDs correspond to: 0x02 - (normally) Front DAC 0x03 - (normally) Rear DAC 0x04 - (normally) CLFE DAC 0x05 - (presumably) side DAC (no side speakers)

0x0c - (normally) Front mixer 0x0d - (normally) Rear mixer 0x0e - (normally) CLFE mixer 0x0f - (presumably) side mixer

0x14 - Front speakers pin 0x15 - Headphones pin (also EAPD for speaker amp) 0x16 - CLFE speakers pin 0x1b - Rear speakers pin

Here's what the codec graph looks like: http://marcansoft.com/transf/codec.png

Any ideas? I'm pretty stumped here. Are there any other magic bits to enable the remaining DACs or mixers?