On 6/20/24 11:10, Krzysztof Kozlowski wrote:

The sdw_initialize_slave() function stores 'slave->prop' as local 'prop' variable, so use it in all applicable places to make code a bit simpler.

Signed-off-by: Krzysztof Kozlowski krzysztof.kozlowski@linaro.org

Reviewed-by: Pierre-Louis Bossart pierre-louis.bossart@linux.intel.com

---

drivers/soundwire/bus.c | 6 +++--- 1 file changed, 3 insertions(+), 3 deletions(-)

diff --git a/drivers/soundwire/bus.c b/drivers/soundwire/bus.c index 191e6cc6f962..263ca32f0c5c 100644 --- a/drivers/soundwire/bus.c +++ b/drivers/soundwire/bus.c @@ -1410,7 +1410,7 @@ static int sdw_initialize_slave(struct sdw_slave *slave) } } if ((slave->bus->prop.quirks & SDW_MASTER_QUIRKS_CLEAR_INITIAL_PARITY) &&

•    !(slave->prop.quirks & SDW_SLAVE_QUIRKS_INVALID_INITIAL_PARITY)) {
  

•    !(prop->quirks & SDW_SLAVE_QUIRKS_INVALID_INITIAL_PARITY)) {
  

  /* Clear parity interrupt before enabling interrupt mask */ status = sdw_read_no_pm(slave, SDW_SCP_INT1); if (status < 0) {

@@ -1436,7 +1436,7 @@ static int sdw_initialize_slave(struct sdw_slave *slave) * device-dependent, it might e.g. only be enabled in * steady-state after a couple of frames. */

• val = slave->prop.scp_int1_mask;

• val = prop->scp_int1_mask;

  /* Enable SCP interrupts */ ret = sdw_update_no_pm(slave, SDW_SCP_INTMASK1, val, val);

@@ -1447,7 +1447,7 @@ static int sdw_initialize_slave(struct sdw_slave *slave) }

/* No need to continue if DP0 is not present */

• if (!slave->prop.dp0_prop)

• if (!prop->dp0_prop) return 0;

  /* Enable DP0 interrupts */