On 02/28/11 18:23, Craig Bourne wrote:

PCI Busmaster Digital I/O System 2 + 24 Channels SPDIF / ADAT Interface

I've digged into the driver source. Your H9652 is more or less a Digiface. The channel *count* was never a question, this is defined by the driver anyway. The remaining question simply was how to label the output destinations.

_From the manual, the answer is pretty obvious: ADAT-1.1 to ADAT-1.8, followed by ADAT-2.1 to ADAT-2.8 and ADAT 3.1-to 3.8, last is S/PDIF.

In double-speed mode (everything above 48kHz), the ADAT channels are cut in half, so ADAT 1.1 to ADAT 1.4, ADAT 2.1 to 2.4 and so on. S/PDIF remains unchanged as it supports higher sample rates at static channel counts (like AES/EBU).

At various times in the past when one was required to specify (e.g., Input/Output) channels to an ALSA tool (or a program that relied on the ALSA sound architecture) a mismatch in this number (presumably of pcm channels) had less than desirable consequences.

We're not talking driver here, the critical parts remain unchanged in the kernel.

All of this leads me to the conjecture that fudging an arbitrary number that stands in for "channels" is perhaps not the best course (not to forget that, at the end of our testing, I would hope that this sound card that costs as much as the computer that houses it will not have suffered any damage).

Of course, this is open source. It comes without any warranty and you're free to avoid it, but to the best of my knowledge, you must not be afraid.

Firstly, it's userspace, so nothing can really kill your card. Second, the whole logic is an FPGA, so it can always be flashed to a working state if something goes wrong (it cannot go wrong, as you cannot accidentally flash your card). Last but not least: the channel count has always been correct, 26 all the time, only the name array was missing.

So we have this "read 26 channel names from the naming array", and it's now a question which names to write in there. I've given the answer above, but want to stress again that we're talking pure C pure userland here, so it's close to a hello world program:

printf("Channel name is %s\n", name_array[channel_number]);

with name_array being something like { "ADAT-1.1", "ADAT-1.2", .. } and so on. Right now, with the package prepared by Fernando, you'll simply see "1", "2", .. "26" instead of "ADAT-1.1", but this will change in a minute.

HTH