At Thu, 26 Jun 2014 13:30:25 +0300, Tanu Kaskinen wrote:

At least PulseAudio needs special handling for dummy devices. To allow that to happen automatically, the UCM configuration should contain the information about which PCMs are dummy.

Signed-off-by: Tanu Kaskinen tanu.kaskinen@linux.intel.com

Thanks, applied with Liam's ack.

Takashi

---

include/use-case.h | 10 ++++++++++ 1 file changed, 10 insertions(+)

diff --git a/include/use-case.h b/include/use-case.h index 4e13249..f30168f 100644 --- a/include/use-case.h +++ b/include/use-case.h @@ -258,7 +258,17 @@ int snd_use_case_get_list(snd_use_case_mgr_t *uc_mgr,

• Recommended names for values:
• TQ - Tone Quality
• PlaybackPCM - full PCM playback device name

• • PlaybackPCMIsDummy - Valid values: "yes" and "no". If set to "yes", the

• • 	  PCM named by the PlaybackPCM value is a dummy device,
    

• • 	  meaning that opening it enables an audio path in the
    

• • 	  hardware, but writing to the PCM device has no
    

• • 	  effect.
    

  • CapturePCM - full PCM capture device name
• • CapturePCMIsDummy - Valid values: "yes" and "no". If set to "yes", the

• • 	  PCM named by the CapturePCM value is a dummy device,
    

• • 	  meaning that opening it enables an audio path in the
    

• • 	  hardware, but reading from the PCM device has no
    

• • 	  effect.
    

  • PlaybackRate - playback device sample rate
  • PlaybackChannels - playback device channel count
  • PlaybackCTL - playback control device name

-- 1.9.3

---

Alsa-devel mailing list Alsa-devel@alsa-project.org http://mailman.alsa-project.org/mailman/listinfo/alsa-devel