On Thu, 03 Dec 2015 15:46:57 +0100, David Henningsson wrote:

I've tested it on one device and it works fine, no clicks.

Signed-off-by: David Henningsson david.henningsson@canonical.com

OK, applied now.

---

Alsa-info for this device is available here: https://launchpadlibrarian.net/228090406/AlsaInfo.txt

Possibly it works well for other chips too, but this is the only one I have tested.

Btw; I noticed another thing which I wonder whether it's correct or not: If I run "hda-emu AlsaInfo.txt", all nodes are in D3. But after running "P 0 p", some nodes (e g the internal speaker pin) stays in D0. Is that expected?

Yes.

I thought all pins would go down to D3 when playback closes. Same behaviour is seen on the real hardware, too.

It's for sticky converter. There was an issue where powering up/down there triggers the click noise. So we keep the converter and the rest on as default once when assigned and used.

This can be likely optimized out with the modern chips, I suppose.

thanks,

Takashi

sound/pci/hda/patch_conexant.c | 3 +++ 1 file changed, 3 insertions(+)

diff --git a/sound/pci/hda/patch_conexant.c b/sound/pci/hda/patch_conexant.c index ef19890..6122b8c 100644 --- a/sound/pci/hda/patch_conexant.c +++ b/sound/pci/hda/patch_conexant.c @@ -901,6 +901,9 @@ static int patch_conexant_auto(struct hda_codec *codec) snd_hda_pick_fixup(codec, cxt5051_fixup_models, cxt5051_fixups, cxt_fixups); break;

• case 0x14f150f2:

• codec->power_save_node = 1;
  

• /* Fall through */
  

  default: codec->pin_amp_workaround = 1; snd_hda_pick_fixup(codec, cxt5066_fixup_models,

-- 1.9.1