On Tue, Sep 07, 2021 at 05:11:09PM +0800, Shengjiu Wang wrote:

...

There is a noise issue for 8kHz sample rate on slave mode. Compared with master mode, the difference is the DACDIV setting, after correcting the DACDIV, the noise is gone.

There is no noise issue for 48kHz sample rate, because the default value of DACDIV is correct for 48kHz.

So wm8960_configure_clocking() should be functional for ADC and DAC function even if it is slave mode.

In order to be compatible for old use case, just add condition for checking that sysclk is zero with slave mode.

Fixes: 0e50b51aa22f ("ASoC: wm8960: Let wm8960 driver configure its bit clock and frame clock") Signed-off-by: Shengjiu Wang shengjiu.wang@nxp.com

---

sound/soc/codecs/wm8960.c | 2 +- 1 file changed, 1 insertion(+), 1 deletion(-)

diff --git a/sound/soc/codecs/wm8960.c b/sound/soc/codecs/wm8960.c index 9e621a254392..9c6af76a60fd 100644 --- a/sound/soc/codecs/wm8960.c +++ b/sound/soc/codecs/wm8960.c @@ -742,7 +742,7 @@ static int wm8960_configure_clocking(struct

snd_soc_component *component)

...

  int i, j, k;
  int ret;

• if (!(iface1 & (1<<6))) {
  

• if (!(iface1 & (1 << 6)) && !wm8960->sysclk) {
          dev_dbg(component->dev,
                  "Codec is slave mode, no need to configure
  

clock\n");

Looking through the datasheet it just looks like this if statement has always been non-sense, it looks pretty clear the clocking should still be configured in slave mode (apart from BCLKDIV which is presumably ignored in slave mode).

I would be slightly inclined to suggest it would be better to just fixup any systems not setting sysclk for slave mode, but I am assuming you are talking primarily about out of tree systems. So I think we need to at least update the message here as well, it should probably change to a warning and state that the we are proceeding with no clock configuration, rather than erroneously saying it doesn't need one.

Thanks, Charles

Sorry for missing your email. I will update it in v2. Thanks.

Best regards Wang Shengjiu