Dear ALSA Community,

I am new to this community and have a basic knowledge on ASoC architecture. I have worked a few times with Freescale's boards and the SGTL5000 Codec driver.

Now, time has come for me to develop a ASoC Codec Driver for an Audio DSP (ST Microelectronics STA309A). Obviously, this driver should work only on the Playback stream. This chip supports up to 8 playback channels (I2S format) and has up to 8 output channels. There are also 8 internal channels, whose inputs can be one of the 8 playback channels and outputs are connected to one of each 8 output channels like this:

Playback Channel X --> Input Channel Y --> Output Channel Z

This DSP has several controls to apply effects and modify volume on each channel internal channel individually. I have been able to implement snd_kcontrol_new for them successfully and I am able to control them from the userspace correctly.

The part I am still in doubt on how to proceed is related to this channel routing. From what I have researched, this could be designed on top of DAPM Widgets and DAPM Routes in a way that the machine-level driver could configure this routing according to the specific board and the userspace would not be required to deal with this stuff.

I want to develop a device driver following the ASoC architecture so I can use it in different boards and in a way it could be useful for other developers.

Here is what I was sketching up for this snd_soc_codec_driver:

static const char *input_names[8] = { "DIN1", "DIN2", "DIN3", "DIN4", "DIN5", "DIN6", "DIN7", "DIN8" }; static const char *internal_names[8] = { "INT1", "INT2", "INT3", "INT4", "INT5", "INT6", "INT7", "INT8" };

/* Playback Channel to Internal DSP Channel Mapping */ static SOC_ENUM_SINGLE_DECL(int1mux, STA309A_C12IM, 0, input_names); static const struct snd_kcontrol_new int1mux_ctrl = SOC_DAPM_ENUM("INT1MUX", int1mux); .... replicated to all 8 internal channels

/* Internal DSP Channel to Output Channel Mapping */ static SOC_ENUM_SINGLE_DECL(out1mux, STA309A_C12OM, 0, internal_names); static const struct snd_kcontrol_new out1mux_ctrl = SOC_DAPM_ENUM("OUT1MUX", out1mux); .... replicated to all 8 output channels

static const struct snd_soc_dapm_widget sta309a_dsp_dapm_widgets[] = { SND_SOC_DAPM_MUX("INT1MUX", SND_SOC_NOPM, 0, 0, &int1mux_ctrl), .... added 8 internal channel muxes

SND_SOC_DAPM_MUX("OUT1MUX", SND_SOC_NOPM, 0, 0, &out1mux_ctrl), .... added 8 output channel muxes };

Now I am lost on how to declare the possible routes. It should be possible to route each playback channel to any of the 8 possible internal channels and the internal channels to any of the 8 possible output channels. Note that this DSP supports Cross-Overs, so one can route a playback channel to one or more internal channels. Analogously, one can route an internal channel to one or more output channels.

I have not started to develop the machine-level driver, but any thoughts on how to design it would be very helpful. In the machine-level driver, I would like to define the DSP routing for an specific board. How can I do it?

Thank you very much.

Mauricio Cirelli