[PATCH v4] dt-bindings: sound: tlv320aic3x: Convert to dtschema
Convert bindings for TI's TLV320AIC3x audio codecs to dtschema.
The following properties are still found in some old dts files, but will be ignored by the driver: - adc-settle-ms - assigned-clock-parents, assigned-clock-rates, assigned-clocks - port
Signed-off-by: Jai Luthra j-luthra@ti.com ---
Changes in v4: - Use generic node name in the example - Fix typo in commit message
v3: https://lore.kernel.org/linux-devicetree/20221220123951.29959-1-j-luthra@ti.... v2: https://lore.kernel.org/linux-devicetree/20220803151726.31628-1-j-luthra@ti....
.../bindings/sound/ti,tlv320aic3x.yaml | 158 ++++++++++++++++++ .../devicetree/bindings/sound/tlv320aic3x.txt | 97 ----------- 2 files changed, 158 insertions(+), 97 deletions(-) create mode 100644 Documentation/devicetree/bindings/sound/ti,tlv320aic3x.yaml delete mode 100644 Documentation/devicetree/bindings/sound/tlv320aic3x.txt
diff --git a/Documentation/devicetree/bindings/sound/ti,tlv320aic3x.yaml b/Documentation/devicetree/bindings/sound/ti,tlv320aic3x.yaml new file mode 100644 index 000000000000..f0375bbf4c40 --- /dev/null +++ b/Documentation/devicetree/bindings/sound/ti,tlv320aic3x.yaml @@ -0,0 +1,158 @@ +# SPDX-License-Identifier: GPL-2.0-only OR BSD-2-Clause +# Copyright (C) 2022 Texas Instruments Incorporated +%YAML 1.2 +--- +$id: http://devicetree.org/schemas/sound/ti,tlv320aic3x.yaml# +$schema: http://devicetree.org/meta-schemas/core.yaml# + +title: Texas Instruments TLV320AIC3x Codec + +description: | + TLV320AIC3x are a series of low-power stereo audio codecs with stereo + headphone amplifier, as well as multiple inputs and outputs programmable in + single-ended or fully differential configurations. + + The serial control bus supports SPI or I2C protocols, while the serial audio + data bus is programmable for I2S, left/right-justified, DSP, or TDM modes. + + The following pins can be referred in the sound node's audio routing property: + + CODEC output pins: + LLOUT + RLOUT + MONO_LOUT + HPLOUT + HPROUT + HPLCOM + HPRCOM + + CODEC input pins for TLV320AIC3104: + MIC2L + MIC2R + LINE1L + LINE1R + + CODEC input pins for other compatible codecs: + MIC3L + MIC3R + LINE1L + LINE2L + LINE1R + LINE2R + +maintainers: + - Jai Luthra j-luthra@ti.com + +properties: + compatible: + enum: + - ti,tlv320aic3x + - ti,tlv320aic33 + - ti,tlv320aic3007 + - ti,tlv320aic3106 + - ti,tlv320aic3104 + + reg: + maxItems: 1 + + reset-gpios: + maxItems: 1 + description: + GPIO specification for the active low RESET input. + + gpio-reset: + maxItems: 1 + description: + Deprecated, please use reset-gpios instead. + deprecated: true + + ai3x-gpio-func: + description: AIC3X_GPIO1 & AIC3X_GPIO2 Functionality + $ref: /schemas/types.yaml#/definitions/uint32-array + maxItems: 2 + + ai3x-micbias-vg: + description: MicBias required voltage. If node is omitted then MicBias is powered down. + $ref: /schemas/types.yaml#/definitions/uint32 + oneOf: + - const: 1 + description: MICBIAS output is powered to 2.0V. + - const: 2 + description: MICBIAS output is powered to 2.5V. + - const: 3 + description: MICBIAS output is connected to AVDD. + + ai3x-ocmv: + description: Output Common-Mode Voltage selection. + $ref: /schemas/types.yaml#/definitions/uint32 + oneOf: + - const: 0 + description: 1.35V + - const: 1 + description: 1.5V + - const: 2 + description: 1.65V + - const: 3 + description: 1.8V + + AVDD-supply: + description: Analog DAC voltage. + + IOVDD-supply: + description: I/O voltage. + + DRVDD-supply: + description: ADC analog and output driver voltage. + + DVDD-supply: + description: Digital core voltage. + + '#sound-dai-cells': + const: 0 + +required: + - compatible + - reg + +additionalProperties: false + +examples: + - | + #include <dt-bindings/gpio/gpio.h> + i2c { + #address-cells = <1>; + #size-cells = <0>; + + tlv320aic3x_i2c: audio-codec@1b { + compatible = "ti,tlv320aic3x"; + reg = <0x1b>; + + reset-gpios = <&gpio1 17 GPIO_ACTIVE_LOW>; + + AVDD-supply = <®ulator>; + IOVDD-supply = <®ulator>; + DRVDD-supply = <®ulator>; + DVDD-supply = <®ulator>; + }; + }; + + - | + #include <dt-bindings/gpio/gpio.h> + spi { + #address-cells = <1>; + #size-cells = <0>; + + tlv320aic3x_spi: audio-codec@0 { + compatible = "ti,tlv320aic3x"; + reg = <0>; /* CS number */ + #sound-dai-cells = <0>; + + AVDD-supply = <®ulator>; + IOVDD-supply = <®ulator>; + DRVDD-supply = <®ulator>; + DVDD-supply = <®ulator>; + ai3x-ocmv = <0>; + }; + }; + +... diff --git a/Documentation/devicetree/bindings/sound/tlv320aic3x.txt b/Documentation/devicetree/bindings/sound/tlv320aic3x.txt deleted file mode 100644 index 20931a63fd64..000000000000 --- a/Documentation/devicetree/bindings/sound/tlv320aic3x.txt +++ /dev/null @@ -1,97 +0,0 @@ -Texas Instruments - tlv320aic3x Codec module - -The tlv320aic3x serial control bus communicates through both I2C and SPI bus protocols - -Required properties: - -- compatible - "string" - One of: - "ti,tlv320aic3x" - Generic TLV320AIC3x device - "ti,tlv320aic33" - TLV320AIC33 - "ti,tlv320aic3007" - TLV320AIC3007 - "ti,tlv320aic3106" - TLV320AIC3106 - "ti,tlv320aic3104" - TLV320AIC3104 - - -- reg - <int> - I2C slave address - - -Optional properties: - -- reset-gpios - GPIO specification for the active low RESET input. -- ai3x-gpio-func - <array of 2 int> - AIC3X_GPIO1 & AIC3X_GPIO2 Functionality - - Not supported on tlv320aic3104 -- ai3x-micbias-vg - MicBias Voltage required. - 1 - MICBIAS output is powered to 2.0V, - 2 - MICBIAS output is powered to 2.5V, - 3 - MICBIAS output is connected to AVDD, - If this node is not mentioned or if the value is incorrect, then MicBias - is powered down. -- ai3x-ocmv - Output Common-Mode Voltage selection: - 0 - 1.35V, - 1 - 1.5V, - 2 - 1.65V, - 3 - 1.8V -- AVDD-supply, IOVDD-supply, DRVDD-supply, DVDD-supply : power supplies for the - device as covered in Documentation/devicetree/bindings/regulator/regulator.txt - -Deprecated properties: - -- gpio-reset - gpio pin number used for codec reset - -CODEC output pins: - * LLOUT - * RLOUT - * MONO_LOUT - * HPLOUT - * HPROUT - * HPLCOM - * HPRCOM - -CODEC input pins for TLV320AIC3104: - * MIC2L - * MIC2R - * LINE1L - * LINE1R - -CODEC input pins for other compatible codecs: - * MIC3L - * MIC3R - * LINE1L - * LINE2L - * LINE1R - * LINE2R - -The pins can be used in referring sound node's audio-routing property. - -I2C example: - -#include <dt-bindings/gpio/gpio.h> - -tlv320aic3x: tlv320aic3x@1b { - compatible = "ti,tlv320aic3x"; - reg = <0x1b>; - - reset-gpios = <&gpio1 17 GPIO_ACTIVE_LOW>; - - AVDD-supply = <®ulator>; - IOVDD-supply = <®ulator>; - DRVDD-supply = <®ulator>; - DVDD-supply = <®ulator>; -}; - -SPI example: - -spi0: spi@f0000000 { - tlv320aic3x: codec@0 { - compatible = "ti,tlv320aic3x"; - reg = <0>; /* CS number */ - #sound-dai-cells = <0>; - spi-max-frequency = <1000000>; - - AVDD-supply = <®ulator>; - IOVDD-supply = <®ulator>; - DRVDD-supply = <®ulator>; - DVDD-supply = <®ulator>; - ai3x-ocmv = <0>; - }; -};
On 21/12/2022 15:52, Jai Luthra wrote:
Convert bindings for TI's TLV320AIC3x audio codecs to dtschema.
The following properties are still found in some old dts files, but will be ignored by the driver:
- adc-settle-ms
- assigned-clock-parents, assigned-clock-rates, assigned-clocks
- port
Signed-off-by: Jai Luthra j-luthra@ti.com
Reviewed-by: Krzysztof Kozlowski krzysztof.kozlowski@linaro.org
Best regards, Krzysztof
On Wed, Dec 21, 2022 at 08:22:16PM +0530, Jai Luthra wrote:
Convert bindings for TI's TLV320AIC3x audio codecs to dtschema.
The following properties are still found in some old dts files, but will be ignored by the driver:
- assigned-clock-parents, assigned-clock-rates, assigned-clocks
These are from the common clock binding and will be handled by the clock code.
Hi Mark,
On 22/12/22 17:10, Mark Brown wrote:
On Wed, Dec 21, 2022 at 08:22:16PM +0530, Jai Luthra wrote:
Convert bindings for TI's TLV320AIC3x audio codecs to dtschema.
The following properties are still found in some old dts files, but will be ignored by the driver:
- assigned-clock-parents, assigned-clock-rates, assigned-clocks
These are from the common clock binding and will be handled by the clock code.
Thanks, I will send v5 where a follow-up commit adds the missing properties for clocks and port in the binding.
-- Jai
On Wed, 21 Dec 2022 20:22:16 +0530, Jai Luthra wrote:
Convert bindings for TI's TLV320AIC3x audio codecs to dtschema.
The following properties are still found in some old dts files, but will be ignored by the driver:
- adc-settle-ms
- assigned-clock-parents, assigned-clock-rates, assigned-clocks
- port
[...]
Applied to
https://git.kernel.org/pub/scm/linux/kernel/git/broonie/sound.git for-next
Thanks!
[1/1] dt-bindings: sound: tlv320aic3x: Convert to dtschema commit: b66cd83547dabc0ba582e2de716c20c810a21124
All being well this means that it will be integrated into the linux-next tree (usually sometime in the next 24 hours) and sent to Linus during the next merge window (or sooner if it is a bug fix), however if problems are discovered then the patch may be dropped or reverted.
You may get further e-mails resulting from automated or manual testing and review of the tree, please engage with people reporting problems and send followup patches addressing any issues that are reported if needed.
If any updates are required or you are submitting further changes they should be sent as incremental updates against current git, existing patches will not be replaced.
Please add any relevant lists and maintainers to the CCs when replying to this mail.
Thanks, Mark
participants (3)
-
Jai Luthra -
Krzysztof Kozlowski -
Mark Brown