This card works in the latest but of course the pci id needs changed. I also have the same issue with the Auzentech X-Fi Forte, but changing the pci id makes this card work fine. Just make sure to change the appropriate id for 20k1 cards (pci models (Prelude)) vs 20k2 (pcie models (Forte))

Info on card:

03:00.0 0403: 1102:000b (rev 03) 03:00.0 Audio device: Creative Labs X-Fi Titanium series [EMU20k2] (rev 03) Subsystem: Device 5431:0049 Flags: bus master, fast devsel, latency 0, IRQ 30 Memory at fbaf0000 (64-bit, non-prefetchable) [size=64K] Memory at fb800000 (64-bit, non-prefetchable) [size=2M] Memory at f4000000 (64-bit, non-prefetchable) [size=64M] Capabilities: [40] Power Management version 3 Capabilities: [48] MSI: Mask- 64bit+ Count=1/1 Enable- Capabilities: [58] Express Endpoint, MSI 00 Capabilities: [100] Device Serial Number ff-ff-ff-ff-ff-ff-ff-ff Capabilities: [300] Advanced Error Reporting Kernel driver in use: SB-XFi Kernel modules: ctxfi

Support for these pci id's need added to the driver.

On Sun, 21 Jun 2009 01:12:08 -0700 Kamil Kaminski kamilkss@gmail.com wrote:

Hi guys, I noticed that latest alsa-driver-unstable does not detect my card as if PCI IDs were discarded or purposely disabled to only work on Creative cards, the earlier snapshots used to work fine. This is what I get:

ctatc: Card not recognised ctxfi: Something wrong!!! SB-XFi: probe of 0000:06:01.0 failed with error -2

This is the card:

06:01.0 Multimedia audio controller: Creative Labs SB X-Fi Subsystem: Auzentech, Inc. Device 0034 Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B- DisINTx- Status: Cap+ 66MHz- UDF- FastB2B- ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR- INTx- Latency: 64 (1000ns min, 1250ns max) Interrupt: pin A routed to IRQ 22 Region 0: I/O ports at 8f00 [size=32] Region 1: Memory at dfc00000 (64-bit, non-prefetchable) [size=2M] Region 3: Memory at d8000000 (64-bit, non-prefetchable) [size=64M] Capabilities: [40] Power Management version 2 Flags: PMEClk- DSI+ D1+ D2+ AuxCurrent=0mA PME(D0-,D1-,D2-,D3hot-,D3cold-) Status: D0 PME-Enable- DSel=0 DScale=0 PME- Capabilities: [50] MSI: Mask- 64bit+ Count=1/1 Enable- Address: 0000000000000000 Data: 0000 Kernel driver in use: CTALSA Kernel modules: ctxfi

I'm currently using v1.0 ctxfi alsa driver from Creative, It would be nice to have Auzentech X-Fi Prelude working in 2.6.31 kernel ;)

Thanks. _______________________________________________ Alsa-devel mailing list Alsa-devel@alsa-project.org http://mailman.alsa-project.org/mailman/listinfo/alsa-devel