patch 1: move the mxs dma header to a more common place. Beside the mx23/mx28, the apbh-dma is also used by MX50 and MX6Q. So move the mxs dma header file to a more common place, and rename it to mxs-dma.h
patch 2: rewrite the last parameter of mxs_dma_prep_slave_sg(). In the new GPMI version, some hardware behavior changes. The WAIT4END bit should be set in the middle one of the ECC READ page DMA chain. The DMA chain should be set like this:
+-----+ +-----+ +-----+ | cmd | ------------> | cmd | ------------------> | cmd | +-----+ +-----+ +-----+ ^ ^ | | | | set WAIT4END here too set WAIT4END here
So rewrite the last parameter of mxs_dma_prep_slave_sg(), use the dma_ctrl_flags to set the proper DMA bit for DMA Command Structure. And change the relative drivers with the dma_ctrl_flags.
TEST: Tested the mxs-mmc driver and gpmi-nand drive with the two patches in MX28 board.
v1 --> v2: [1] squash the trial patches into single patch. [2] use the dma_ctrl_flags.
Huang Shijie (2): mxs-dma : move the mxs dma.h to a more common place mxs-dma : rewrite the last parameter of mxs_dma_prep_slave_sg()
drivers/dma/mxs-dma.c | 34 +++++++++++++++++--- drivers/mmc/host/mxs-mmc.c | 12 +++--- drivers/mtd/nand/gpmi-nand/gpmi-lib.c | 28 +++++++++++++--- drivers/mtd/nand/gpmi-nand/gpmi-nand.h | 6 +++- drivers/mtd/nand/gpmi-nand/gpmi-regs.h | 2 + .../include/mach/dma.h => include/linux/mxs-dma.h | 0 sound/soc/mxs/mxs-pcm.c | 2 +- sound/soc/mxs/mxs-pcm.h | 2 +- sound/soc/mxs/mxs-saif.c | 2 +- 9 files changed, 67 insertions(+), 21 deletions(-) rename arch/arm/mach-mxs/include/mach/dma.h => include/linux/mxs-dma.h (100%)