Fix grammar and typos.
Besides that, also fix the comment about the range of SYS_MCLK, which is from 8 to 27 MHz.
Signed-off-by: Fabio Estevam fabio.estevam@freescale.com --- sound/soc/codecs/sgtl5000.c | 27 ++++++++++++++------------- 1 file changed, 14 insertions(+), 13 deletions(-)
diff --git a/sound/soc/codecs/sgtl5000.c b/sound/soc/codecs/sgtl5000.c index 6bb77d7..10160e7 100644 --- a/sound/soc/codecs/sgtl5000.c +++ b/sound/soc/codecs/sgtl5000.c @@ -530,16 +530,16 @@ static int sgtl5000_set_dai_sysclk(struct snd_soc_dai *codec_dai,
/* * set clock according to i2s frame clock, - * sgtl5000 provide 2 clock sources. - * 1. sys_mclk. sample freq can only configure to + * sgtl5000 provides 2 clock sources: + * 1. sys_mclk: sample freq can only be configured to * 1/256, 1/384, 1/512 of sys_mclk. - * 2. pll. can derive any audio clocks. + * 2. pll: can derive any audio clocks. * * clock setting rules: - * 1. in slave mode, only sys_mclk can use. - * 2. as constraint by sys_mclk, sample freq should - * set to 32k, 44.1k and above. - * 3. using sys_mclk prefer to pll to save power. + * 1. in slave mode, only sys_mclk can be used + * 2. as constraint by sys_mclk, sample freq should be set to 32 kHz, 44.1 kHz + * and above. + * 3. usage of sys_mclk is preferred over pll to save power. */ static int sgtl5000_set_clock(struct snd_soc_codec *codec, int frame_rate) { @@ -549,8 +549,8 @@ static int sgtl5000_set_clock(struct snd_soc_codec *codec, int frame_rate)
/* * sample freq should be divided by frame clock, - * if frame clock lower than 44.1khz, sample feq should set to - * 32khz or 44.1khz. + * if frame clock is lower than 44.1 kHz, sample freq should be set to + * 32 kHz or 44.1 kHz. */ switch (frame_rate) { case 8000: @@ -603,7 +603,8 @@ static int sgtl5000_set_clock(struct snd_soc_codec *codec, int frame_rate)
/* * calculate the divider of mclk/sample_freq, - * factor of freq =96k can only be 256, since mclk in range (12m,27m) + * factor of freq = 96 kHz can only be 256, since mclk is in the range + * of 8 MHz - 27 MHz */ switch (sgtl5000->sysclk / sys_fs) { case 256: @@ -619,7 +620,7 @@ static int sgtl5000_set_clock(struct snd_soc_codec *codec, int frame_rate) SGTL5000_MCLK_FREQ_SHIFT; break; default: - /* if mclk not satisify the divider, use pll */ + /* if mclk does not satisfy the divider, use pll */ if (sgtl5000->master) { clk_ctl |= SGTL5000_MCLK_FREQ_PLL << SGTL5000_MCLK_FREQ_SHIFT; @@ -795,7 +796,7 @@ static int ldo_regulator_enable(struct regulator_dev *dev) SGTL5000_LINEREG_D_POWERUP, SGTL5000_LINEREG_D_POWERUP);
- /* when internal ldo enabled, simple digital power can be disabled */ + /* when internal ldo is enabled, simple digital power can be disabled */ snd_soc_update_bits(codec, SGTL5000_CHIP_ANA_POWER, SGTL5000_LINREG_SIMPLE_POWERUP, 0); @@ -1079,7 +1080,7 @@ static bool sgtl5000_readable(struct device *dev, unsigned int reg) /* * sgtl5000 has 3 internal power supplies: * 1. VAG, normally set to vdda/2 - * 2. chargepump, set to different value + * 2. charge pump, set to different value * according to voltage of vdda and vddio * 3. line out VAG, normally set to vddio/2 *