On Sat, 2008-12-13 at 18:42 +0100, Rafael J. Wysocki wrote:
On Saturday, 13 of December 2008, Maxim Levitsky wrote:
On Sat, 2008-12-13 at 14:35 +0100, Rafael J. Wysocki wrote:
On Saturday, 13 of December 2008, Maxim Levitsky wrote:
So, big thanks for everything.
Now aspire one linux support is very close to perfect, (only problem left is that wireless is limited to 18Mbits/s raw rate, but at some point I or developers of ath5k will get to the bottom of this)
I also noticed, that now the SD only card reader is always enabled regardless of card been there while booting, and same happens in windows, I suspect that this is permanent hardware change, which worries me, but this reader works fine otherwise. (This is another reason why binary bioses are evil, go and find out why it enables it)
Also forgot to mention that both readers ignore write protect tab on SD card, and I will report this to correct mailing list soon. Everything else works fine
please include acpiphp fix in 2.6.28.
Which one is this?
acpiphp: Identify more removable slots
According to section 6.3.6 of the ACPI spec, the presence of an _RMV method that evaluates to 1 is sufficient to indicate that a slot is removable without needing an eject method. This patch refactors the ejectable slot detection code a little in order to flag these slots as ejectable and register them. Acpihp therefore binds to the expresscard slot on my HP test machine. Signed-off-by: Matthew Garrett <mjg@redhat.com>this makes acpiphp handle hotplug of (now one, sd reader is somehow always present) card reader.
This is http://git.kernel.org/?p=linux/kernel/git/jbarnes/pci-2.6.git;a=commit;h=db9... in the PCI tree.
It's scheduled for 2.6.29 and may be included into 2.6.28 -stable, but please remember to notify the stable team as soon as this patch gets merged into the mainline.
I will, sure.
Just to note, that I might not need that patch as I told that now one of readers is permanently enabled, I don't know why but this seems to be hardware failure.
I disconnected power/battery, no cards are in slots, and yet on boot there is a sd reader in lspci. Same happens in windows. It could happen due to suspend/resume, If I remember correctly I put card once in slot, and then for whole week system wasn't rebooted, but instead went through suspend/resume cycles.
One thing for sure, nobody will fix this (I mean no point to call acer support, this is too minor problem)
What I worry about is that second one could show same behavier. I like this hotplug, as it allows me to test pci hotplug code for real. Besides, this isn't done without purpose, device might draw less power this way.
Best regards, Maxim Levitsky