After the CX20442 codec driver already takes care of enabling the codec power for itself, but before dropping the old bias control method from the Amstrad Delta ASoC sound card file, which in fact keeps the modem power always on, even after the ASoC device close for now, extend the modem setup with a power management callback, which toggles the regulator up to the modem's needs, reusing the previously set up regulator consumer for this. Also, drop the MODEM_NRESET pin setup from the modem initialization procedure, as this operation was already ineffective since patch 1/4, and not needed because the regulator is set up as initially enabled.
Depends on patch 1/4 "ARM: OMAP1: ams-delta: set up a regulator over the modem reset GPIO pin" to apply cleanly, and requires patch 2/4 "ASoC: cx20442: add bias control over a platform provided regulator" for the sound card / codec bundle to still work.
Signed-off-by: Janusz Krzysztofik jkrzyszt@tis.icnet.pl Cc: Tony Lindgren tony@atomide.com --- No functional changes against initial version.
arch/arm/mach-omap1/board-ams-delta.c | 22 +++++++++++++++++----- 1 files changed, 17 insertions(+), 5 deletions(-)
diff --git a/arch/arm/mach-omap1/board-ams-delta.c b/arch/arm/mach-omap1/board-ams-delta.c index 43dcbda..cfcf871 100644 --- a/arch/arm/mach-omap1/board-ams-delta.c +++ b/arch/arm/mach-omap1/board-ams-delta.c @@ -526,6 +526,16 @@ static void __init ams_delta_init(void) omap_writew(omap_readw(ARM_RSTCT1) | 0x0004, ARM_RSTCT1); }
+static void modem_pm(struct uart_port *port, unsigned int state, unsigned old) +{ + struct modem_private_data *priv = port->private_data; + + if (state == old) + return; + + regulator_toggle(priv, state == 0); +} + static struct plat_serial8250_port ams_delta_modem_ports[] = { { .membase = IOMEM(MODEM_VIRT), @@ -536,6 +546,8 @@ static struct plat_serial8250_port ams_delta_modem_ports[] = { .iotype = UPIO_MEM, .regshift = 1, .uartclk = BASE_BAUD * 16, + .pm = modem_pm, + .private_data = &modem_priv, }, { }, }; @@ -584,9 +596,8 @@ static int __init late_init(void) mutex_init(&modem_priv.consumer.lock); modem_priv.regulator = ERR_PTR(-ENODEV);
- ams_delta_latch2_write( - AMS_DELTA_LATCH2_MODEM_NRESET | AMS_DELTA_LATCH2_MODEM_CODEC, - AMS_DELTA_LATCH2_MODEM_NRESET | AMS_DELTA_LATCH2_MODEM_CODEC); + ams_delta_latch2_write(AMS_DELTA_LATCH2_MODEM_CODEC, + AMS_DELTA_LATCH2_MODEM_CODEC);
err = platform_device_register(&ams_delta_modem_device); if (err) @@ -595,8 +606,9 @@ static int __init late_init(void) /* * Once the modem device is registered, the modem_nreset * regulator can be requested on behalf of that device. - * The regulator is used via ams_delta_latch_write() - * by the modem and ASoC drivers until updated. + * In addition to the modem .pm callback, that regulator + * is still used via the ams_delta_latch_write() wrapper + * by the ASoC driver until updated. */ modem_priv.regulator = regulator_get(&ams_delta_modem_device.dev, "RESET#");