From: "Damien.Horsley" Damien.Horsley@imgtec.com
Add documentation for the controls present in the SPDIF input controller driver
Signed-off-by: Damien.Horsley Damien.Horsley@imgtec.com --- Documentation/sound/alsa/img,spdif-in.txt | 49 +++++++++++++++++++++++++++++++ 1 file changed, 49 insertions(+) create mode 100644 Documentation/sound/alsa/img,spdif-in.txt
diff --git a/Documentation/sound/alsa/img,spdif-in.txt b/Documentation/sound/alsa/img,spdif-in.txt new file mode 100644 index 0000000..8b75057 --- /dev/null +++ b/Documentation/sound/alsa/img,spdif-in.txt @@ -0,0 +1,49 @@ +The Imagination Technologies SPDIF Input controller contains the following +controls: + +name='IEC958 Capture Mask',index=0 + +This control returns a mask that shows which of the IEC958 status bits +can be read using the 'IEC958 Capture Default' control. + +name='IEC958 Capture Default',index=0 + +This control returns the status bits contained within the SPDIF stream that +is being received. The 'IEC958 Capture Mask' shows which bits can be read +from this control. + +name='SPDIF In Multi Frequency Acquire',index=0 +name='SPDIF In Multi Frequency Acquire',index=1 +name='SPDIF In Multi Frequency Acquire',index=2 +name='SPDIF In Multi Frequency Acquire',index=3 + +This control is used to attempt acquisition of up to four different sample +rates. The active rate can be obtained by reading the 'SPDIF In Lock Frequency' +control. + +When the value of this control is set to {0,0,0,0}, the rate given to hw_params +will determine the single rate the block will capture. Else, the rate given to +hw_params will be ignored, and the block will attempt capture for each of the +four sample rates set here. + +If less than four rates are required, the same rate can be specified more than +once + +name='SPDIF In Lock Frequency',index=0 + +This control returns the active capture rate, or 0 if a lock has not been +acquired + +name='SPDIF In Lock TRK',index=0 + +This control is used to modify the locking/jitter rejection characteristics +of the block. Larger values increase the locking range, but reduce jitter +rejection. + +name='SPDIF In Lock Acquire Threshold',index=0 + +This control is used to change the threshold at which a lock is acquired. + +name='SPDIF In Lock Release Threshold',index=0 + +This control is used to change the threshold at which a lock is released.