On Wed, Sep 12, 2012 at 06:26:18PM +0530, Ashish Chavan wrote:
On Wed, 2012-09-12 at 10:57 +0800, Mark Brown wrote:
Why is any of this being exposed to userspace? If this should be configured I'd expect it to be static platform data, not something that gets changed at runtime.
These parameters are exposed considering the fact that DMIC itself is not part of the codec. Codec only provides DMIC interface using which an external DMIC can be attached. These parameters depend on the actual DMIC hardware and hence kept configurable to allow runtime plug in of any DMIC hardware. Doesn't it make sense to keep them runtime configurable?
No. The only realistic way to attach a new DMIC to a board is to solder it down, that's not something people are going to do while the system is actve. It's something that's fixed at PCB design time.
- /* In slave mode, there is only one set of divisors */
- if (!da9055->master)
fout = 2822400;
Should check the user supplied this value
Can you explain which value / user supplied value you are referring to? It is not quite clear to me.
The specified output frequency, you just totally ignore it.
For other things like input mixers, Headphone and Lineouts, DAPM is already used to control power specific bits. The confusion is because there are two separate control bits for these blocks. One bit is for "Enabling" that block and other is for "Enabling Amplifier" of that block. e.g for headphone, one bit is for "output enable" while other is for "output amplifier enable".
So document this.