Hi,
When we don't have any active component between the output of the codec and the speaker/jack the codec emmits pop noise due to several factors: - RESET register is toggled by regcache_sync (patch 1) - After regcache_sync we need to wait a bit to allow the codec to settle down: the codec will be soft reseted when it is powered down, so when we power it on and run regcache_sync, we need to wait for the flushed settings to be valid. (patch 2) - The HP ouptut power-down mode can be changed to be driven weakly to VCM, this can reduce the pop noise as well, with slight increase in powere consumption.
These factors were not taken care as in n810 and n900 we have external active amplifiers and they will remove any artifacts coming from the codec, but on boards w/o active external components they can reach the output.
Regards, Peter --- Peter Ujfalusi (3): ASoC: tlv320aic3x: Mark the RESET register as volatile ASoC: tlv320aic3x: Add delay after power on and register sync ASoC: tlv320aic3x: Add controls for selecting HP power down modes
sound/soc/codecs/tlv320aic3x.c | 29 +++++++++++++++++++++++++++++ 1 file changed, 29 insertions(+)