Dear Huang Shijie,
于 2012年10月18日 15:14, Marek Vasut 写道:
Dear Huang Shijie,
Why such massive CC ?
于 2012年10月18日 14:18, Vinod Koul 写道:
Why cant you do start (prepare clock etc) when you submit the descriptor to dmaengine. Can be done in tx_submit callback. Similarly remove the clock when dma transaction gets completed.
I ever thought this method too.
But it will become low efficient in the following case: Assuming the gpmi-nand driver has to read out 1024 pages in one
_SINGLE_ read operation. The gpmi-nand will submit the descriptor to dmaengine per page.
It will? Then GPMI NAND is flat our broken ... again.
yes.
Please read the NAND chip spec about the comand READ PAGE(00h-30h) and the code nand_do_read_ops(). The nand chip limits us only read one page out one time. So the driver will submit the descriptor to dmaengine per page.
So we can't stream data from the chip? About time to adjust the MTD framework to allow that. Maybe implement a command queue?
So with your method, the system will repeat the enable/disable dma clock 1024 time.
Yes, it is the driver that's wrong.
not the driver.
At every enable/disable dma clock, the system has to enable the clock chain and it's parents ...
But with this patch, we only need to enable/disable dma clock one time, just at we select the nand chip.
You are fixing a driver problem at a framework level, wrong.
So, check how the MXS SPI driver handles descriptor chaining. Indeed, the Sigmatel screwed the DMA stuff good. But if you analyze the SPI driver, you'll notice a few important points that might come handy when you fix the GPMI NAND driver properly.
The direction to take here is:
- Implement DMA chaining into the GPMI NAND driver
How can i implement the DMA chain if the nand chip READ-PAGE command gives us the one page limit?
This smells like a time to extend the MTD api ?
thanks Huang Shijie
- You might need to do one PIO transfer to reconfigure the IP registers
between each segment of the DMA chain (just as MXS SPI does it) 3) You might run out of DMA descriptors when doing too long chains -- so you might need to fix that part of the mxs DMA driver.
Best regards, Marek Vasut