On Fri, Sep 30, 2022 at 12:59:24PM +0800, Wang, Xiaolei wrote:
On 9/29/2022 5:24 PM, Charles Keepax wrote:
On Wed, Sep 28, 2022 at 02:44:30AM +0000, Wang, Xiaolei wrote:
snd_soc_bind_card snd_soc_dapm_new_widgets soc_dapm_read snd_soc_component_read(dapm->component, reg);
There is no runtime resume, which cannot perform normal reading and writing for volatile reg, because it has been switched to regcache only in the process of runtime suspend. I can't find the right place to resume, can you give me any advice?
I think the first step would be could you clarify which register is being read here? Reading a volatile register as part of setting up the widgets does feel rather problematic.
Yes, this is reading the 0x30 register of the wm8962, it can adjust Microphone Bias Voltage.
Yes, that is some rather poor hardware design there, the chip has a bunch of volatile status bits mixed in with a bunch of non-volatile control bits in the same register. It would seem the problem is likely the two widgets TEMP_HP and TEMP_SPK.
Probably the simplest solution would be to add an event handler for TEMP_HP and TEMP_SPK and move the register handling in there, if there is no register specified on the widgets the core will not attempt to read it on probe and will assume the widget is off. Although you will also need to turn them off during probe as they do default to on.
Is that something you are comfortable writing a patch for or do you want me to have a look at pulling one together for you? Although note this might take a few days and I don't have hardware to test it here.
Thanks, Charles