The sdw_initialize_slave() function stores 'slave->prop' as local 'prop' variable, so use it in all applicable places to make code a bit simpler.
Signed-off-by: Krzysztof Kozlowski krzysztof.kozlowski@linaro.org --- drivers/soundwire/bus.c | 6 +++--- 1 file changed, 3 insertions(+), 3 deletions(-)
diff --git a/drivers/soundwire/bus.c b/drivers/soundwire/bus.c index 191e6cc6f962..263ca32f0c5c 100644 --- a/drivers/soundwire/bus.c +++ b/drivers/soundwire/bus.c @@ -1410,7 +1410,7 @@ static int sdw_initialize_slave(struct sdw_slave *slave) } } if ((slave->bus->prop.quirks & SDW_MASTER_QUIRKS_CLEAR_INITIAL_PARITY) && - !(slave->prop.quirks & SDW_SLAVE_QUIRKS_INVALID_INITIAL_PARITY)) { + !(prop->quirks & SDW_SLAVE_QUIRKS_INVALID_INITIAL_PARITY)) { /* Clear parity interrupt before enabling interrupt mask */ status = sdw_read_no_pm(slave, SDW_SCP_INT1); if (status < 0) { @@ -1436,7 +1436,7 @@ static int sdw_initialize_slave(struct sdw_slave *slave) * device-dependent, it might e.g. only be enabled in * steady-state after a couple of frames. */ - val = slave->prop.scp_int1_mask; + val = prop->scp_int1_mask;
/* Enable SCP interrupts */ ret = sdw_update_no_pm(slave, SDW_SCP_INTMASK1, val, val); @@ -1447,7 +1447,7 @@ static int sdw_initialize_slave(struct sdw_slave *slave) }
/* No need to continue if DP0 is not present */ - if (!slave->prop.dp0_prop) + if (!prop->dp0_prop) return 0;
/* Enable DP0 interrupts */