On Wed, 22 Jun 2011 00:04:43 -0500 Philip Chu Philip.Chu@logicpd.com wrote:
HI,
I got a problem with my audio capture using McBSP 3 port on OMAP 3530. Linux kernel 2.6.32. For the very first audio data capture, when I expect to receive only one exact period of data through McBSP, PCM DMA ISR never comes. When I check the DMA pointer by using snd_pcm_update_hw_ptr_pos(), I found it was just trash value. If I ask the data sender to send 4 samples more than the period defined, DMA ISR gets fired, the it points to the exact period position, and I assume the extra 4 bytes just get lost?
My McBSP is configured as a slave which needs the sender to provide Frame Sync, clocks etc, and those signals are designed to just kick in at the same time. Do the clock signal need to be present earlier than the Frame Sync?
Anybody knows what the issue could be?
Sounds like the last sample(s) may stay in McBSP receive shift register and they get copied to receive buffer and forward only until the receiver is running again.
I'm thinking is this missing interrupt due missing first sample. Do you receive it and does the received data look correct?
It could be that the McBSP expects a stable bit-clock before frame-sync until it starts to receive data into shift register. I'm not sure about this.
Another reason could be that the DAI format is not correct. I.e. if the transmitter has 0-bit data delay after frame-sync but McBSP is configured for 1-bit so 1 bit is missing from shift register when the transmission ends. But then just a single bit-clock cycle, not the full word should kick the data forward and DMA ISR should occur.